[PATCH 1/2] ARM64: dts: meson-gxm: Add R-Box Pro

Andreas Färber afaerber at suse.de
Mon Jan 16 19:35:10 PST 2017


Am 17.01.2017 um 04:06 schrieb Andreas Färber:
> +	leds {
> +		compatible = "gpio-leds";
> +
> +		blue {
> +			label = "rbox-pro:blue:on";
> +			gpios = <&gpio_ao GPIOAO_9 GPIO_ACTIVE_HIGH>;
> +			default-state = "on";
> +		};
> +
> +		red {
> +			label = "rbox-pro:red:standby";
> +			gpios = <&gpio GPIODV_28 GPIO_ACTIVE_HIGH>;
> +			default-state = "off";
> +			retain-state-suspended;
> +			panic-indicator;
> +		};
> +	};

The original property names for these two were led and red. If anyone
has better label names than the above, please speak up. Ditto for
vega-s95. On the odroidc2 it's called alive but uses heartbeat there.

The vendor device tree had a third "mcu" GPIO in the sysled node,
GPIOAO_6, which leads to immediate power-off. I tried using
"gpio-poweroff" to configure this pin, but that driver fails to
initialize because some pm callback is already registered - I assume
from psci, which apparently succeeds to power-off the system, too. For
comparison, the S905 based Vega S95 Telos has no such mcu property. Any
thoughts?

Also, any ideas how best to switch from blue to red for suspend? Add
pinctrl properties above? systemd service doing echo from userspace? I
assume in Android the Amlogic sysled driver handles all that logic -
didn't find any suspend equivalent to gpio-poweroff.

Regards,
Andreas

-- 
SUSE Linux GmbH, Maxfeldstr. 5, 90409 Nürnberg, Germany
GF: Felix Imendörffer, Jane Smithard, Graham Norton
HRB 21284 (AG Nürnberg)



More information about the linux-arm-kernel mailing list