[PATCH 09/12] pinctrl: samsung: Add infrastructure for pin-bank retention control

[Krzysztof Kozlowski]

On Mon, Jan 16, 2017 at 07:45:04AM +0100, Marek Szyprowski wrote:
> Pad retention control after suspend/resume cycle should be done from pin
> controller driver instead of PMU (power management unit) driver to avoid
> possible ordering and logical dependencies. Till now it worked fine only
> because PMU driver registered its sys_ops after pin controller.
> 
> This patch adds infrastructure to handle pad retention during pin control
> driver resume.
> 
> Signed-off-by: Marek Szyprowski <m.szyprowski at samsung.com>
> ---
>  drivers/pinctrl/samsung/pinctrl-samsung.c | 12 ++++++---
>  drivers/pinctrl/samsung/pinctrl-samsung.h | 42 +++++++++++++++++++++++++++++++
>  2 files changed, 51 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/pinctrl/samsung/pinctrl-samsung.c b/drivers/pinctrl/samsung/pinctrl-samsung.c
> index 86f23842f681..95a84086a2e9 100644
> --- a/drivers/pinctrl/samsung/pinctrl-samsung.c
> +++ b/drivers/pinctrl/samsung/pinctrl-samsung.c
> @@ -1075,6 +1075,9 @@ static int samsung_pinctrl_probe(struct platform_device *pdev)
>  		ctrl->eint_gpio_init(drvdata);
>  	if (ctrl->eint_wkup_init)
>  		ctrl->eint_wkup_init(drvdata);
> +	if (ctrl->retention_data && ctrl->retention_data->init)
> +		drvdata->retention_ctrl = ctrl->retention_data->init(drvdata,
> +							  ctrl->retention_data);
>  
>  	platform_set_drvdata(pdev, drvdata);
>  
> @@ -1127,15 +1130,15 @@ static void samsung_pinctrl_suspend_dev(
>  
>  	if (drvdata->suspend)
>  		drvdata->suspend(drvdata);
> +	if (drvdata->retention_ctrl && drvdata->retention_ctrl->on)
> +		drvdata->retention_ctrl->on(drvdata);
> +

This new line is not needed (checkpatch might complain... either in
normal mode or in strict). Beside that, thanks for splitting the
patch for interface from the implementation:

Reviewed-by: Krzysztof Kozlowski <krzk at kernel.org>

Best regards,
Krzysztof