[PATCH 03/10] devicetree: bindings: add bindings for ahci-da850

[David Lechner]

On 01/13/2017 06:37 AM, Bartosz Golaszewski wrote:
> Add DT bindings for the TI DA850 AHCI SATA controller.
>
> Signed-off-by: Bartosz Golaszewski <bgolaszewski at baylibre.com>
> ---
>  .../devicetree/bindings/ata/ahci-da850.txt          | 21 +++++++++++++++++++++
>  1 file changed, 21 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/ata/ahci-da850.txt
>
> diff --git a/Documentation/devicetree/bindings/ata/ahci-da850.txt b/Documentation/devicetree/bindings/ata/ahci-da850.txt
> new file mode 100644
> index 0000000..d07c241
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/ata/ahci-da850.txt
> @@ -0,0 +1,21 @@
> +Device tree binding for the TI DA850 AHCI SATA Controller
> +---------------------------------------------------------
> +
> +Required properties:
> +  - compatible: must be "ti,da850-ahci"
> +  - reg: physical base addresses and sizes of the controller's register areas
> +  - interrupts: interrupt specifier (refer to the interrupt binding)
> +
> +Optional properties:
> +  - clocks: clock specifier (refer to the common clock binding)
> +  - da850,clk_multiplier: the multiplier for the reference clock needed
> +                          for 1.5GHz PLL output

A clock multiplier property seems redundant if you are specifying a 
clock. It should be possible to get the rate from the clock to determine 
which multiplier is needed.

> +
> +Example:
> +
> +	sata: ahci at 0x218000 {
> +		compatible = "ti,da850-ahci";
> +		reg = <0x218000 0x2000>, <0x22c018 0x4>;
> +		interrupts = <67>;
> +		da850,clk_multiplier = <7>;
> +	};
>