[PATCH v4 1/2] power: reset: add linkstation-reset driver
ryan at nardis.ca
Sun Jan 8 09:02:09 PST 2017
On Sun, Jan 08, 2017 at 12:04:50AM +0900, Roger Shimizu wrote:
>+ bool "Buffalo Linkstation and its variants reset driver"
>+ depends on OF_GPIO && PLAT_ORION
>+ This driver supports power off Buffalo Linkstation / KuroBox Pro
>+ NAS and their variants by sending commands to the micro-controller
>+ which controls the main power.
>+ Say Y if you have a Buffalo Linkstation / KuroBox Pro NAS.
Would it make sense to mention something about these being the
ARM9/orion5x Linkstations? If I understand correctly, the older PPC
Linkstations have a single-byte poweroff command. (Maybe they could even
be supported by qnap-poweroff.)
See arch/powerpc/platforms/embedded6xx/linkstation.c around line 123,
More information about the linux-arm-kernel