[PATCH v2 0/8] ASoC: sunxi: Add support for audio codec in A23/H3 SoCs
Chen-Yu Tsai
wens at csie.org
Sat Jan 7 11:00:40 PST 2017
Hi Maxime,
On Fri, Nov 25, 2016 at 8:34 PM, Chen-Yu Tsai <wens at csie.org> wrote:
> Hi everyone,
>
> This is v2 of my Allwinner A23 and H3 audio codec support series.
>
> Changes since v1:
>
> - Use DEFINE_RES_MEM for the analog path controls block resources.
> - Added Rob's ack.
>
> This series adds support for the audio codec found in Allwinner A23 and
> H3 SoCs. The design and data paths are similar to the audio codec found
> in earlier SoCs such as the A31. The analog audio paths are symmetrical
> with left/right channels and down-mix selectors for mono differential
> output.
>
> What deviates from previous SoCs is that the analog path controls have
> been moved to a separate control bus, accessed through a message box
> like register interface in the PRCM block. This necessitates writing
> a separate component driver for it, which is then tied into the sound
> card as an ASoC auxiliary device.
>
> Patch 1 adds the analog path controls block to the sun6i-prcm driver as
> a sub-device, for the A23. The H3 currently does not use the PRCM driver.
>
> Patch 2 adds PCM and card support for the A23 codec to the sun4i-codec
> driver.
>
> Patch 3 adds a device node for the analog path controls block to the A23
> dtsi.
>
> Patch 4 adds a device node for the audio codec, and the phandle for the
> analog path controls block to the A23 dtsi.
>
> Patch 5 enables the audio codec for the A23 Q8 tablets. On these tablets
> the headphone output is driven in DC coupled, or "direct drive", mode.
>
> Patch 6 adds PCM and card support for the H3 codec to the sun4i-codec
> driver.
>
> Patch 7 adds device nodes for the audio codec and analog path controls
> block to the H3 dtsi.
>
> Patch 8 enables the audio codec on the Orange Pi PC. The audio output
> jack on the board is tied to the line out pins on the SoC.
All the driver bits are in. Can you pick up the dts patches?
Thanks
ChenYu
>
>
> Please take a look and let me know what you think.
>
> In addition, the sun4i-codec driver is getting pretty large. Maybe we
> want to split the different parts into different files?
>
>
> Regards
> ChenYu
>
>
> Chen-Yu Tsai (8):
> mfd: sun6i-prcm: Add codec analog controls sub-device for Allwinner
> A23
> ASoC: sun4i-codec: Add support for A23 codec
> ARM: dts: sun8i: Add codec analog path controls node in PRCM for
> A23/A33
> ARM: dts: sun8i-a23: Add device node for internal audio codec
> ARM: dts: sun8i-a23: q8-tablet: Enable internal audio codec
> ASoC: sun4i-codec: Add support for H3 codec
> ARM: dts: sun8i-h3: Add device nodes for audio codec and its analog
> controls
> ARM: dts: sun8i-h3: orange-pi-pc: Enable audio codec
>
> .../devicetree/bindings/sound/sun4i-codec.txt | 14 +-
> arch/arm/boot/dts/sun8i-a23-a33.dtsi | 4 +
> arch/arm/boot/dts/sun8i-a23-q8-tablet.dts | 23 +++
> arch/arm/boot/dts/sun8i-a23.dtsi | 16 ++
> arch/arm/boot/dts/sun8i-h3-orangepi-pc.dts | 8 +
> arch/arm/boot/dts/sun8i-h3.dtsi | 19 +++
> drivers/mfd/sun6i-prcm.c | 13 ++
> sound/soc/sunxi/sun4i-codec.c | 179 +++++++++++++++++++++
> 8 files changed, 274 insertions(+), 2 deletions(-)
>
> --
> 2.10.2
>
More information about the linux-arm-kernel
mailing list