[PATCH 1/2] arm64: dma_mapping: allow PCI host driver to limit DMA mask

[Grygorii Strashko]

On 01/03/2017 01:01 PM, Nikita Yushchenko wrote:
>>> It is possible that PCI device supports 64-bit DMA addressing, and thus
>>> it's driver sets device's dma_mask to DMA_BIT_MASK(64), however PCI host
>>> bridge has limitations on inbound transactions addressing. Example of
>>> such setup is NVME SSD device connected to RCAR PCIe controller.
>>>
>>> Previously there was attempt to handle this via bus notifier: after
>>> driver is attached to PCI device, bridge driver gets notifier callback,
>>> and resets dma_mask from there. However, this is racy: PCI device driver
>>> could already allocate buffers and/or start i/o in probe routine.
>>> In NVME case, i/o is started in workqueue context, and this race gives
>>> "sometimes works, sometimes not" effect.
>>>
>>> Proper solution should make driver's dma_set_mask() call to fail if host
>>> bridge can't support mask being set.
>>>
>>> This patch makes __swiotlb_dma_supported() to check mask being set for
>>> PCI device against dma_mask of struct device corresponding to PCI host
>>> bridge (one with name "pciXXXX:YY"), if that dma_mask is set.
>>>
>>> This is the least destructive approach: currently dma_mask of that device
>>> object is not used anyhow, thus all existing setups will work as before,
>>> and modification is required only in actually affected components -
>>> driver of particular PCI host bridge, and dma_map_ops of particular
>>> platform.
>>>
>>> Signed-off-by: Nikita Yushchenko <nikita.yoush at cogentembedded.com>
>>> ---
>>>  arch/arm64/mm/dma-mapping.c | 11 +++++++++++
>>>  1 file changed, 11 insertions(+)
>>>
>>> diff --git a/arch/arm64/mm/dma-mapping.c b/arch/arm64/mm/dma-mapping.c
>>> index 290a84f..49645277 100644
>>> --- a/arch/arm64/mm/dma-mapping.c
>>> +++ b/arch/arm64/mm/dma-mapping.c
>>> @@ -28,6 +28,7 @@
>>>  #include <linux/dma-contiguous.h>
>>>  #include <linux/vmalloc.h>
>>>  #include <linux/swiotlb.h>
>>> +#include <linux/pci.h>
>>>  
>>>  #include <asm/cacheflush.h>
>>>  
>>> @@ -347,6 +348,16 @@ static int __swiotlb_get_sgtable(struct device *dev, struct sg_table *sgt,
>>>  
>>>  static int __swiotlb_dma_supported(struct device *hwdev, u64 mask)
>>>  {
>>> +#ifdef CONFIG_PCI
>>> +	if (dev_is_pci(hwdev)) {
>>> +		struct pci_dev *pdev = to_pci_dev(hwdev);
>>> +		struct pci_host_bridge *br = pci_find_host_bridge(pdev->bus);
>>> +
>>> +		if (br->dev.dma_mask && (*br->dev.dma_mask) &&
>>> +				(mask & (*br->dev.dma_mask)) != mask)
>>> +			return 0;
>>> +	}
>>> +#endif
>>
>> Hmm, but this makes it look like the problem is both arm64 and swiotlb
>> specific, when in reality it's not. Perhaps another hack you could try
>> would be to register a PCI bus notifier in the host bridge looking for
>> BUS_NOTIFY_BIND_DRIVER, then you could proxy the DMA ops for each child
>> device before the driver has probed, but adding a dma_set_mask callback
>> to limit the mask to what you need?
> 
> This is what Renesas BSP tries to do and it does not work.
> 
> BUS_NOTIFY_BIND_DRIVER arrives after driver's probe routine exits, but
> i/o can be started before that.

Hm. This is strange statement:
 really_probe
 |->driver_sysfs_add
    |-> blocking_notifier_call_chain(&dev->bus->p->bus_notifier,
 					     BUS_NOTIFY_BIND_DRIVER, dev);
...
 |- ret = drv->probe(dev);
...
 |- driver_bound(dev);
    |- blocking_notifier_call_chain(&dev->bus->p->bus_notifier,
					     BUS_NOTIFY_BOUND_DRIVER, dev);

Am I missing smth?

-- 
regards,
-grygorii