[PATCH] ARM: dts: imx: Add memory node unit name

[Marco Franchi]

Hi Lothar,

2017-12-21 6:07 GMT-02:00 Lothar Waßmann <LW at karo-electronics.de>:
> Hi,
>
> On Wed,  6 Dec 2017 13:59:49 -0200 Marco Franchi wrote:
>> Fix the following warnings from dtc by adding the unit name to memory
>> nodes:
>>
>> Warning (unit_address_vs_reg): Node /memory has a reg or ranges property, but no unit name
>>
>> Converted using the following command:
>>
>> perl -p0777i -e 's/memory \{\n\t\treg = \<0x+([0-9a-f])/memory\@$1$\0000000 \{\n\t\treg = <0x$1/m' `find ./arch/arm/boot/dts -name "imx*"`
>>
>> The files below were manually fixed:
>> -imx1-ads.dts
>> -imx1-apf9328.dts
>>
> The imx*.dtsi files all have this:
> |       memory { device_type = "memory"; reg = <0 0>; };
> Thus you will end up with a 'memory' node with a reg = <0 0> entry and
> an additional 'memory at ...' node with the correct 'reg' values.

You are right. The .dtb files were composed by two different memory nodes.
Do you have some recommendation to take off this specific warning?

>
>
> Lothar Waßmann

Marco Franchi