[PATCH 7/9] bus: ti-sysc: Handle module quirks based dts configuration
Tony Lindgren
tony at atomide.com
Fri Dec 15 10:08:58 PST 2017
Let's configure few module quirks via device tree using the
properties for "ti,no-idle-on-init", "ti,no-reset-on-init"
and "ti,sysc-delay-us".
Let's also reorder the probe a bit so we have pdata available
earlier, and move the PM runtime calls to sysc_init_module()
from sysc_read_revision().
Signed-off-by: Tony Lindgren <tony at atomide.com>
---
drivers/bus/ti-sysc.c | 114 ++++++++++++++++++++++++++++------
include/linux/platform_data/ti-sysc.h | 6 ++
2 files changed, 102 insertions(+), 18 deletions(-)
diff --git a/drivers/bus/ti-sysc.c b/drivers/bus/ti-sysc.c
--- a/drivers/bus/ti-sysc.c
+++ b/drivers/bus/ti-sysc.c
@@ -50,6 +50,8 @@ static const char * const clock_names[] = { "fck", "ick", };
* @legacy_mode: configured for legacy mode if set
* @cap: interconnect target module capabilities
* @cfg: interconnect target module configuration
+ * @name: name if available
+ * @revision: interconnect target module revision
*/
struct sysc {
struct device *dev;
@@ -61,12 +63,32 @@ struct sysc {
const char *legacy_mode;
const struct sysc_capabilities *cap;
struct sysc_config cfg;
+ const char *name;
+ u32 revision;
};
+static u32 sysc_read(struct sysc *ddata, int offset)
+{
+ if (ddata->cfg.quirks & SYSC_QUIRK_16BIT) {
+ u32 val;
+
+ val = readw_relaxed(ddata->module_va + offset);
+ val |= (readw_relaxed(ddata->module_va + offset + 4) << 16);
+
+ return val;
+ }
+
+ return readl_relaxed(ddata->module_va + offset);
+}
+
static u32 sysc_read_revision(struct sysc *ddata)
{
- return readl_relaxed(ddata->module_va +
- ddata->offsets[SYSC_REVISION]);
+ int offset = ddata->offsets[SYSC_REVISION];
+
+ if (offset < 0)
+ return 0;
+
+ return sysc_read(ddata, offset);
}
static int sysc_get_one_clock(struct sysc *ddata,
@@ -393,22 +415,12 @@ static int sysc_map_and_check_registers(struct sysc *ddata)
*/
static int sysc_show_rev(char *bufp, struct sysc *ddata)
{
- int error, len;
+ int len;
if (ddata->offsets[SYSC_REVISION] < 0)
return sprintf(bufp, ":NA");
- error = pm_runtime_get_sync(ddata->dev);
- if (error < 0) {
- pm_runtime_put_noidle(ddata->dev);
-
- return 0;
- }
-
- len = sprintf(bufp, ":%08x", sysc_read_revision(ddata));
-
- pm_runtime_mark_last_busy(ddata->dev);
- pm_runtime_put_autosuspend(ddata->dev);
+ len = sprintf(bufp, ":%08x", ddata->revision);
return len;
}
@@ -488,6 +500,66 @@ static const struct dev_pm_ops sysc_pm_ops = {
NULL)
};
+/* At this point the module is configured enough to read the revision */
+static int sysc_init_module(struct sysc *ddata)
+{
+ int error;
+
+ error = pm_runtime_get_sync(ddata->dev);
+ if (error < 0) {
+ pm_runtime_put_noidle(ddata->dev);
+
+ return 0;
+ }
+ ddata->revision = sysc_read_revision(ddata);
+ pm_runtime_put_sync(ddata->dev);
+
+ return 0;
+}
+
+/* Device tree configured quirks */
+struct sysc_dts_quirk {
+ const char *name;
+ u32 mask;
+};
+
+static const struct sysc_dts_quirk sysc_dts_quirks[] = {
+ { .name = "ti,no-idle-on-init",
+ .mask = SYSC_QUIRK_NO_IDLE_ON_INIT, },
+ { .name = "ti,no-reset-on-init",
+ .mask = SYSC_QUIRK_NO_RESET_ON_INIT, },
+};
+
+static int sysc_init_dts_quirks(struct sysc *ddata)
+{
+ struct device_node *np = ddata->dev->of_node;
+ const struct property *prop;
+ int i, len, error;
+ u32 val;
+
+ ddata->legacy_mode = of_get_property(np, "ti,hwmods", NULL);
+
+ for (i = 0; i < ARRAY_SIZE(sysc_dts_quirks); i++) {
+ prop = of_get_property(np, sysc_dts_quirks[i].name, &len);
+ if (!prop)
+ break;
+
+ ddata->cfg.quirks |= sysc_dts_quirks[i].mask;
+ }
+
+ error = of_property_read_u32(np, "ti,sysc-delay-us", &val);
+ if (!error) {
+ if (val > 255) {
+ dev_warn(ddata->dev, "bad ti,sysc-delay-us: %i\n",
+ val);
+ }
+
+ ddata->cfg.srst_udelay = (u8)val;
+ }
+
+ return 0;
+}
+
static void sysc_unprepare(struct sysc *ddata)
{
int i;
@@ -722,7 +794,6 @@ static int sysc_init_match(struct sysc *ddata)
static int sysc_probe(struct platform_device *pdev)
{
- struct device_node *np = pdev->dev.of_node;
struct sysc *ddata;
int error;
@@ -731,12 +802,16 @@ static int sysc_probe(struct platform_device *pdev)
return -ENOMEM;
ddata->dev = &pdev->dev;
- ddata->legacy_mode = of_get_property(np, "ti,hwmods", NULL);
+ platform_set_drvdata(pdev, ddata);
error = sysc_init_match(ddata);
if (error)
return error;
+ error = sysc_init_dts_quirks(ddata);
+ if (error)
+ goto unprepare;
+
error = sysc_get_clocks(ddata);
if (error)
return error;
@@ -745,9 +820,12 @@ static int sysc_probe(struct platform_device *pdev)
if (error)
goto unprepare;
- platform_set_drvdata(pdev, ddata);
-
pm_runtime_enable(ddata->dev);
+
+ error = sysc_init_module(ddata);
+ if (error)
+ goto unprepare;
+
error = pm_runtime_get_sync(ddata->dev);
if (error < 0) {
pm_runtime_put_noidle(ddata->dev);
diff --git a/include/linux/platform_data/ti-sysc.h b/include/linux/platform_data/ti-sysc.h
--- a/include/linux/platform_data/ti-sysc.h
+++ b/include/linux/platform_data/ti-sysc.h
@@ -41,6 +41,10 @@ struct sysc_regbits {
s8 emufree_shift;
};
+#define SYSC_QUIRK_NO_IDLE_ON_INIT BIT(6)
+#define SYSC_QUIRK_NO_RESET_ON_INIT BIT(5)
+#define SYSC_QUIRK_OPT_CLKS_NEEDED BIT(4)
+#define SYSC_QUIRK_OPT_CLKS_IN_RESET BIT(3)
#define SYSC_QUIRK_16BIT BIT(2)
#define SYSC_QUIRK_UNCACHED BIT(1)
#define SYSC_QUIRK_USE_CLOCKACT BIT(0)
@@ -61,9 +65,11 @@ struct sysc_capabilities {
/**
* struct sysc_config - configuration for an interconnect target module
+ * @srst_udelay: optional delay needed after OCP soft reset
* @quirks: bitmask of enabled quirks
*/
struct sysc_config {
+ u8 srst_udelay;
u32 quirks;
};
--
2.15.0
More information about the linux-arm-kernel
mailing list