[PATCH v2] ARM64: dts: meson-axg: add ethernet mac controller

Yixun Lan yixun.lan at amlogic.com
Thu Dec 14 17:46:49 PST 2017


Hi Jerome:

On 12/15/17 00:45, Jerome Brunet wrote:
> On Thu, 2017-12-14 at 11:02 +0800, Yixun Lan wrote:
>> ---
>> Changes in v2 since [1]:
>>  - rebase to kevin's v4.16/dt64 branch
>>  - add Neil's Reviewed-by
>>  - move clock info to board.dts instead of in soc.dtsi
> 
> You got this comment regarding the pwm clock setup. the setup of the pwm clocks
> depends on the use case, so should defined depending on the requirement on the
> board
> 
Yes, I thought it was a convention to put the clock into board.dts ..

I think it's more clear if you could have a three level hierarchy:
 arch.dtsi. soc.dtsi, board.dts
   most of clock and pinctrl could go to soc.dtsi

> This is not the case for the ethmac, the clock setup will be same for every
> board, unless I missed something. the clock bindings should be defined in
> meson-axg.dtsi, I think
> 
yes, clock should be same

I will send another series to fix this
also will fold the DT separation (for soc.dtsi vs board.dts)

>>  - drop "meson-axg-dwmac" compatible string, since we didn't use this
>>    we could re-add it later when we really need.
>>  - note: to make ethernet work properly,it depend on clock & pinctrl[2],
>>    to compile the DTS, the patch [3] is required.
>>    the code part will be taken via clock & pinctrl subsystem tree.
> 
> .
> 



More information about the linux-arm-kernel mailing list