[PATCH v3 08/11] thermal: armada: Change sensors trim default value

[Miquel Raynal]

Errata #132698 highlights an error in the default value of Tc trim.
Set this parameter to b'011.

Suggested-by: David Sniatkiwicz <davidsn at marvell.com>
Signed-off-by: Miquel Raynal <miquel.raynal at free-electrons.com>
---
 drivers/thermal/armada_thermal.c | 13 +++++++++++++
 1 file changed, 13 insertions(+)

diff --git a/drivers/thermal/armada_thermal.c b/drivers/thermal/armada_thermal.c
index da58a8961a37..be141ca53e83 100644
--- a/drivers/thermal/armada_thermal.c
+++ b/drivers/thermal/armada_thermal.c
@@ -46,6 +46,10 @@
 #define CONTROL0_OFFSET			0x0
 #define CONTROL1_OFFSET			0x4
 
+/* Errata fields */
+#define CONTROL0_TSEN_TC_TRIM_MASK	0x7
+#define CONTROL0_TSEN_TC_TRIM_VAL	0x3
+
 /* TSEN refers to the temperature sensors within the AP */
 #define CONTROL0_TSEN_START		BIT(0)
 #define CONTROL0_TSEN_RESET		BIT(1)
@@ -160,6 +164,15 @@ static void armada380_init_sensor(struct platform_device *pdev,
 	reg &= ~CONTROL1_EXT_TSEN_SW_RESET;
 	writel(reg, priv->control1);
 	msleep(10);
+
+	/* Set Tsen Tc Trim to correct default value (errata #132698) */
+	if (priv->control0) {
+		reg = readl_relaxed(priv->control0);
+		reg &= ~CONTROL0_TSEN_TC_TRIM_MASK;
+		reg |= CONTROL0_TSEN_TC_TRIM_VAL;
+		writel(reg, priv->control0);
+		msleep(10);
+	}
 }
 
 static void armada_ap806_init_sensor(struct platform_device *pdev,
-- 
2.11.0