[PATCH 2/2] arm64: allwinner: a64: bananapi-m64: add usb otg

Chen-Yu Tsai wens at csie.org
Wed Dec 6 19:24:31 PST 2017


On Thu, Dec 7, 2017 at 1:51 AM, Jagan Teki <jagannadh.teki at gmail.com> wrote:
> usb otg on bananapi-m64 has configured with USB-ID with PH9
> and USB-DRVVBUS attached with dcdc1 regulatort.

That is not how you read the schematic...

Intersecting lines that are tied together will have a dot representing
the connection. The DCDC1 line is a pull-up for the ID pin. This is very
clear because it has a resistor connected in series.

VBUS for OTG is controlled by the IC displayed to the right in the
schematic, which is powered from 5V, and controlled by the DRVVBUS
pin from the PMIC. Please take a look at how the A31/A33/A83T board
dts files represent this.

ChenYu



More information about the linux-arm-kernel mailing list