[PATCH v2 10/12] ARM: dts: imx6q-h100: Remove unneeded unit address

[Lucas Stach]

Am Montag, den 04.12.2017, 10:20 -0200 schrieb Fabio Estevam:
> From: Fabio Estevam <fabio.estevam at nxp.com>
> 
> Remove the unneeded unit address for the port nodes in order to fix
> the following build warnings with W=1:
> 
> arch/arm/boot/dts/imx6q-h100.dtb: Warning (unit_address_vs_reg): Node
> /soc/aips-bus at 2100000/i2c at 21a0000/tc358743 at f/port at 0 has a unit name,
> but no reg property
> arch/arm/boot/dts/imx6q-h100.dtb: Warning (unit_address_vs_reg): Node
> /soc/aips-bus at 2100000/mipi at 21dc000/port at 0 has a unit name, but no reg
> property
> 
> Cc: Lucas Stach <l.stach at pengutronix.de>
> Signed-off-by: Fabio Estevam <fabio.estevam at nxp.com>

Reviewed-by: Lucas Stach <l.stach at pengutronix.de>

> ---
> Changes since v1:
> - None
> 
>  arch/arm/boot/dts/imx6q-h100.dts | 4 ++--
>  1 file changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/arch/arm/boot/dts/imx6q-h100.dts
> b/arch/arm/boot/dts/imx6q-h100.dts
> index 743c11f..cc1ce46 100644
> --- a/arch/arm/boot/dts/imx6q-h100.dts
> +++ b/arch/arm/boot/dts/imx6q-h100.dts
> @@ -205,7 +205,7 @@
>  		reset-gpios = <&gpio6 15 GPIO_ACTIVE_LOW>;
>  		/* IRQ has a wrong pull resistor which renders it
> useless  */
>  
> -		port at 0 {
> +		port {
>  			tc358743_out: endpoint {
>  				remote-endpoint = <&mipi_csi2_in>;
>  				data-lanes = <1 2 3 4>;
> @@ -348,7 +348,7 @@
>  &mipi_csi {
>  	status = "okay";
>  
> -	port at 0 {
> +	port {
>  		mipi_csi2_in: endpoint {
>  			remote-endpoint = <&tc358743_out>;
>  			data-lanes = <1 2 3 4>;