[RFC PATCH v9 1/7] edac: thunderx: Remove suspend/resume support

[Jan Glauber]

The memory controller on ThunderX/OcteonTX systems does not
support power management. Therefore remove the suspend/resume
callbacks.

Signed-off-by: Jan Glauber <jglauber at cavium.com>
---
 drivers/edac/thunderx_edac.c | 21 ---------------------
 1 file changed, 21 deletions(-)

diff --git a/drivers/edac/thunderx_edac.c b/drivers/edac/thunderx_edac.c
index 2d352b4..d02bf3b 100644
--- a/drivers/edac/thunderx_edac.c
+++ b/drivers/edac/thunderx_edac.c
@@ -639,27 +639,6 @@ static irqreturn_t thunderx_lmc_threaded_isr(int irq, void *dev_id)
 	return ret;
 }
 
-#ifdef CONFIG_PM
-static int thunderx_lmc_suspend(struct pci_dev *pdev, pm_message_t state)
-{
-	pci_save_state(pdev);
-	pci_disable_device(pdev);
-
-	pci_set_power_state(pdev, pci_choose_state(pdev, state));
-
-	return 0;
-}
-
-static int thunderx_lmc_resume(struct pci_dev *pdev)
-{
-	pci_set_power_state(pdev, PCI_D0);
-	pci_enable_wake(pdev, PCI_D0, 0);
-	pci_restore_state(pdev);
-
-	return 0;
-}
-#endif
-
 static const struct pci_device_id thunderx_lmc_pci_tbl[] = {
 	{ PCI_DEVICE(PCI_VENDOR_ID_CAVIUM, PCI_DEVICE_ID_THUNDER_LMC) },
 	{ 0, },
-- 
2.9.0.rc0.21.g7777322