[PATCH 3/3] mfd: d1w: iproc: Add d1w driver

[Scott Branden]

Hi Lee,


On 17-08-17 03:02 AM, Lee Jones wrote:
> On Wed, 16 Aug 2017, Scott Branden wrote:
>
>> From: Shreesha Rajashekar <shreesha at broadcom.com>
>>
>> d1w bus master controller is added as a mfd node.
> Why?
>
>> ds1wm driver is hooked to this node through the mfd framework.
> Why?
It looks like it was added under mfd as htc-pasic3.c is there
(other than htc-pasic3.c is and mfd due to gpio nodes).

Yes, bcm-iproc-d1w should move under w1 directory.
>
> What makes this an MFD device?
>
>> Signed-off-by: Shreesha Rajashekar <shreesha at broadcom.com>
>> Signed-off-by: Scott Branden <scott.branden at broadcom.com>
>> ---
>>   drivers/mfd/Kconfig         |  11 +++
>>   drivers/mfd/Makefile        |   1 +
>>   drivers/mfd/bcm-iproc-d1w.c | 202 ++++++++++++++++++++++++++++++++++++++++++++
>>   3 files changed, 214 insertions(+)
>>   create mode 100644 drivers/mfd/bcm-iproc-d1w.c