[GIT PULL] Renesas ARM Based SoC DT Updates for v4.14

[Arnd Bergmann]

On Mon, Jul 31, 2017 at 5:19 PM, Simon Horman
<horms+renesas at verge.net.au> wrote:
> Renesas ARM Based SoC DT Updates for v4.14
>
> Changes of note:
>
> * Add pin controller support to the RZ/G1M (r8a7743) SoC and
>   RZ/A1 (r7s72100) SoCs now that the driver is available in v4.13-rc1.
>
> * Add GPIO support to the RZ/G1M (r8a7743) SoC now that the driver
>   is availabe in v4.13-rc1.
>
> * Enable MMCIF0 and Ethernet AVB support on the RZ/G1M (r8a7743) SoC and
>   the iWave-RZG1M-20M Qseven SOM. This depends on newly added pin
>   controller support noted above.
>
> * Use R-Car Gen 2 fallback binding for vin nodes
>
>   This makes binding use consistent across R-Car Gen 2 SoCs.
>   It does not have any run-time effect
>
> * Use SMP jump stub SRAM region from DT on R-Car Gen 2 SoCs
>
>   Geert Uytterhoeven says, "The R-Car Gen2 platform code for CPU core
>   bringup needs to copy a jump stub to on-SoC SRAM.  Currently it uses a
>   hardcoded address pointing to ICRAM1."
>
> * Add Inter Connect RAM to R-Car Gen 2 and RZ/G1 SoCs
>
>   Geert Uytterhoeven says, "R-Car Gen2 and RZ/G1 SoCs contain two or three
>   blocks of SRAM, which can be used for several purposes.  One such purpose
>   is holding a jump stub for CPU core bringup."
> * Use generic compatible string for I2C EEPROM for RZ/A1 (r7s72100) SoC
>   and koelsch board.
>
>   This is part of a tree-wide cleanup by Javier Martinez Canillas

Pulled into next/dt, thanks!

       Arnd