[PATCH v2 1/5] reset: add reset-simple to unify socfpga, stm32, sunxi, and zx2967
Chen-Yu Tsai
wens at csie.org
Fri Aug 11 08:51:39 PDT 2017
On Fri, Aug 11, 2017 at 9:06 PM, Philipp Zabel <p.zabel at pengutronix.de> wrote:
> Split reusable parts out of the sunxi driver, to add a driver for simple
> reset controllers with reset lines that can be controlled by toggling
> bits in exclusive, contiguous register ranges using read-modify-write
> cycles under a spinlock. The separate sunxi driver still remains to
> register the early reset controllers, but it reuses the reset-simple
> ops.
>
> The following patches will replace compatible reset drivers with
> reset-simple, extending it where necessary.
>
> Signed-off-by: Philipp Zabel <p.zabel at pengutronix.de>
> ---
> Changes since v1:
> - Turn reset-simple into a complete platform driver.
> - Move common code out of assert and deassert ops into a helper function.
> - Add inverted flag to support both clear- and set-to-assert reset bits.
> - Remove status readback, will be added in the next patch.
> - Split out SoCFPGA and STM32 conversion into separate patches.
> ---
> drivers/reset/Kconfig | 11 ++++
> drivers/reset/Makefile | 1 +
> drivers/reset/reset-simple.c | 129 +++++++++++++++++++++++++++++++++++++++++++
> drivers/reset/reset-simple.h | 32 +++++++++++
> drivers/reset/reset-sunxi.c | 104 ++--------------------------------
> 5 files changed, 179 insertions(+), 98 deletions(-)
> create mode 100644 drivers/reset/reset-simple.c
> create mode 100644 drivers/reset/reset-simple.h
>
> diff --git a/drivers/reset/Kconfig b/drivers/reset/Kconfig
> index 52d5251660b9b..f7ba01a71daee 100644
> --- a/drivers/reset/Kconfig
> +++ b/drivers/reset/Kconfig
> @@ -68,6 +68,16 @@ config RESET_PISTACHIO
> help
> This enables the reset driver for ImgTec Pistachio SoCs.
>
> +config RESET_SIMPLE
> + bool "Simple Reset Controller Driver" if COMPILE_TEST
> + default ARCH_SUNXI
> + help
> + This enables a simple reset controller driver for reset lines that
> + that can be asserted and deasserted by toggling bits in a contiguous,
> + exclusive register space.
> +
> + Currently this driver supports Allwinner SoCs.
> +
> config RESET_SOCFPGA
> bool "SoCFPGA Reset Driver" if COMPILE_TEST
> default ARCH_SOCFPGA
> @@ -83,6 +93,7 @@ config RESET_STM32
> config RESET_SUNXI
> bool "Allwinner SoCs Reset Driver" if COMPILE_TEST && !ARCH_SUNXI
> default ARCH_SUNXI
> + select RESET_SIMPLE
> help
> This enables the reset driver for Allwinner SoCs.
>
> diff --git a/drivers/reset/Makefile b/drivers/reset/Makefile
> index b62783f50fe5b..ab4af99c3dfdc 100644
> --- a/drivers/reset/Makefile
> +++ b/drivers/reset/Makefile
> @@ -11,6 +11,7 @@ obj-$(CONFIG_RESET_LPC18XX) += reset-lpc18xx.o
> obj-$(CONFIG_RESET_MESON) += reset-meson.o
> obj-$(CONFIG_RESET_OXNAS) += reset-oxnas.o
> obj-$(CONFIG_RESET_PISTACHIO) += reset-pistachio.o
> +obj-$(CONFIG_RESET_SIMPLE) += reset-simple.o
> obj-$(CONFIG_RESET_SOCFPGA) += reset-socfpga.o
> obj-$(CONFIG_RESET_STM32) += reset-stm32.o
> obj-$(CONFIG_RESET_SUNXI) += reset-sunxi.o
> diff --git a/drivers/reset/reset-simple.c b/drivers/reset/reset-simple.c
> new file mode 100644
> index 0000000000000..08fc79d79e86d
> --- /dev/null
> +++ b/drivers/reset/reset-simple.c
> @@ -0,0 +1,129 @@
> +/*
> + * Simple Reset Controller Driver
> + *
> + * Copyright (C) 2017 Pengutronix, Philipp Zabel <kernel at pengutronix.de>
> + *
> + * Based on Allwinner SoCs Reset Controller driver
> + *
> + * Copyright 2013 Maxime Ripard
> + *
> + * Maxime Ripard <maxime.ripard at free-electrons.com>
> + *
> + * This program is free software; you can redistribute it and/or modify
> + * it under the terms of the GNU General Public License as published by
> + * the Free Software Foundation; either version 2 of the License, or
> + * (at your option) any later version.
> + */
> +
> +#include <linux/device.h>
> +#include <linux/err.h>
> +#include <linux/io.h>
> +#include <linux/of.h>
> +#include <linux/of_device.h>
> +#include <linux/platform_device.h>
> +#include <linux/reset-controller.h>
> +#include <linux/spinlock.h>
> +
> +#include "reset-simple.h"
> +
> +static inline struct reset_simple_data *
> +to_reset_simple_data(struct reset_controller_dev *rcdev)
> +{
> + return container_of(rcdev, struct reset_simple_data, rcdev);
> +}
> +
> +static int reset_simple_set(struct reset_controller_dev *rcdev,
> + unsigned long id, bool assert)
> +{
> + struct reset_simple_data *data = to_reset_simple_data(rcdev);
> + int reg_width = sizeof(u32);
> + int bank = id / (reg_width * BITS_PER_BYTE);
> + int offset = id % (reg_width * BITS_PER_BYTE);
> + unsigned long flags;
> + u32 reg;
> +
> + spin_lock_irqsave(&data->lock, flags);
> +
> + reg = readl(data->membase + (bank * reg_width));
> + if (assert ^ data->inverted)
> + reg |= BIT(offset);
> + else
> + reg &= ~BIT(offset);
> + writel(reg, data->membase + (bank * reg_width));
> +
> + spin_unlock_irqrestore(&data->lock, flags);
> +
> + return 0;
> +}
> +
> +static int reset_simple_assert(struct reset_controller_dev *rcdev,
> + unsigned long id)
> +{
> + return reset_simple_set(rcdev, id, true);
> +}
> +
> +static int reset_simple_deassert(struct reset_controller_dev *rcdev,
> + unsigned long id)
> +{
> + return reset_simple_set(rcdev, id, false);
> +}
> +
> +const struct reset_control_ops reset_simple_ops = {
> + .assert = reset_simple_assert,
> + .deassert = reset_simple_deassert,
> +};
> +
> +struct reset_simple_devdata {
> + bool inverted;
> +};
> +
> +static const struct reset_simple_devdata reset_simple_inverted = {
> + .inverted = true,
> +};
> +
> +static const struct of_device_id reset_simple_dt_ids[] = {
> + { .compatible = "allwinner,sun6i-a31-clock-reset",
> + .data = &reset_simple_inverted },
> + { /* sentinel */ },
> +};
> +
> +static int reset_simple_probe(struct platform_device *pdev)
> +{
> + struct device *dev = &pdev->dev;
> + const struct of_device_id *of_id =
> + of_match_device(of_match_ptr(reset_simple_dt_ids), dev);
> + const struct reset_simple_devdata *devdata = of_id->data;
Just use of_device_get_match_data().
> + struct reset_simple_data *data;
> + void __iomem *membase;
> + struct resource *res;
> +
> + data = devm_kzalloc(dev, sizeof(*data), GFP_KERNEL);
> + if (!data)
> + return -ENOMEM;
> +
> + res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
> + membase = devm_ioremap_resource(dev, res);
> + if (IS_ERR(membase))
> + return PTR_ERR(membase);
> +
> + spin_lock_init(&data->lock);
> + data->membase = membase;
> + data->rcdev.owner = THIS_MODULE;
> + data->rcdev.nr_resets = resource_size(res) * BITS_PER_BYTE;
> + data->rcdev.ops = &reset_simple_ops;
> + data->rcdev.of_node = dev->of_node;
> +
> + if (devdata)
> + data->inverted = devdata->inverted;
> +
> + return devm_reset_controller_register(dev, &data->rcdev);
> +}
> +
> +static struct platform_driver reset_simple_driver = {
> + .probe = reset_simple_probe,
> + .driver = {
> + .name = "simple-reset",
> + .of_match_table = reset_simple_dt_ids,
> + },
> +};
> +builtin_platform_driver(reset_simple_driver);
> diff --git a/drivers/reset/reset-simple.h b/drivers/reset/reset-simple.h
> new file mode 100644
> index 0000000000000..a26dc62b2f349
> --- /dev/null
> +++ b/drivers/reset/reset-simple.h
> @@ -0,0 +1,32 @@
> +/*
> + * Simple Reset Controller ops
> + *
> + * Based on Allwinner SoCs Reset Controller driver
> + *
> + * Copyright 2013 Maxime Ripard
> + *
> + * Maxime Ripard <maxime.ripard at free-electrons.com>
> + *
> + * This program is free software; you can redistribute it and/or modify
> + * it under the terms of the GNU General Public License as published by
> + * the Free Software Foundation; either version 2 of the License, or
> + * (at your option) any later version.
> + */
> +
> +#ifndef __RESET_SIMPLE_H__
> +#define __RESET_SIMPLE_H__
> +
> +#include <linux/io.h>
> +#include <linux/reset-controller.h>
> +#include <linux/spinlock.h>
> +
> +struct reset_simple_data {
> + spinlock_t lock;
> + void __iomem *membase;
> + struct reset_controller_dev rcdev;
> + bool inverted;
You should document this option. "Inverted" by itself does not
say a whole lot, as there is no mention about what the normal
or non-inverted behavior is. Is the reset active low (assert
reset when bit is cleared)? Or active high (assert reset when
bit is set)?
ChenYu
More information about the linux-arm-kernel
mailing list