[PATCH 3/4] dt-bindings: mt8173-mtu3: add generic compatible and rename file

[Chunfeng Yun]

On Thu, 2017-08-10 at 21:54 -0500, Rob Herring wrote:
> On Tue, Aug 08, 2017 at 01:42:51PM +0800, Chunfeng Yun wrote:
> > The mt8173-mtu3.txt actually holds the bindings for all mediatek
> > SoCs with usb3 DRD IP, so add a generic compatible and change the
> > name to mtu3.txt.
> > 
> > Signed-off-by: Chunfeng Yun <chunfeng.yun at mediatek.com>
> > ---
> >  .../bindings/usb/{mt8173-mtu3.txt => mtu3.txt}     |    6 ++++--
> >  1 file changed, 4 insertions(+), 2 deletions(-)
> >  rename Documentation/devicetree/bindings/usb/{mt8173-mtu3.txt => mtu3.txt} (95%)
> > 
> > diff --git a/Documentation/devicetree/bindings/usb/mt8173-mtu3.txt b/Documentation/devicetree/bindings/usb/mtu3.txt
> > similarity index 95%
> > rename from Documentation/devicetree/bindings/usb/mt8173-mtu3.txt
> > rename to Documentation/devicetree/bindings/usb/mtu3.txt
> > index 1d7c3bc..832741d 100644
> > --- a/Documentation/devicetree/bindings/usb/mt8173-mtu3.txt
> > +++ b/Documentation/devicetree/bindings/usb/mtu3.txt
> 
> mediatek,mtu3.txt
Ok
> 
> > @@ -1,7 +1,9 @@
> >  The device node for Mediatek USB3.0 DRD controller
> >  
> >  Required properties:
> > - - compatible : should be "mediatek,mt8173-mtu3"
> > + - compatible : should be one of
> > +	"mediatek,mt8173-mtu3" (deprecated, use "mediatek,mtu3" instead),
> 
> NAK. You can add generic compatibles, but you need SoC specific ones in 
> addition.
It's for backward compatibility

> 
> > +	"mediatek,mtu3"
Is it appropriate if changed to "mediatek,generic-mtu3"?

> >   - reg : specifies physical base address and size of the registers
> >   - reg-names: should be "mac" for device IP and "ippc" for IP port control
> >   - interrupts : interrupt used by the device IP
> > @@ -44,7 +46,7 @@ Optional properties:
> >  Sub-nodes:
> >  The xhci should be added as subnode to mtu3 as shown in the following example
> >  if host mode is enabled. The DT binding details of xhci can be found in:
> > -Documentation/devicetree/bindings/usb/mt8173-xhci.txt
> > +Documentation/devicetree/bindings/usb/xhci-mtk.txt
> 
> This should be in the patch that renames this file.
Ok
> 
> >  
> >  Example:
> >  ssusb: usb at 11271000 {
> > -- 
> > 1.7.9.5
> >