[PATCH 1/7] mtd: spi-nor: cadence-quadspi: add a delay in write sequence

[Rob Herring]

On Tue, Aug 01, 2017 at 10:24:28AM +0530, Vignesh R wrote:
> As per 66AK2G02 TRM[1] SPRUHY8F section 11.15.5.3 Indirect Access
> Controller programming sequence, a delay equal to couple QSPI master
> clock(~5ns) is required after setting CQSPI_REG_INDIRECTWR_START bit and
> writing data to the flash. Add a new compatible to handle the couple of
> cycles of delay required in the indirect write sequence, since this
> delay is specific to TI 66AK2G SoC.
> 
> [1]http://www.ti.com/lit/ug/spruhy8f/spruhy8f.pdf
> 
> Signed-off-by: Vignesh R <vigneshr at ti.com>
> ---
>  Documentation/devicetree/bindings/mtd/cadence-quadspi.txt |  1 +
>  drivers/mtd/spi-nor/cadence-quadspi.c                     | 13 +++++++++++++
>  2 files changed, 14 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/mtd/cadence-quadspi.txt b/Documentation/devicetree/bindings/mtd/cadence-quadspi.txt
> index f248056da24c..fdd511a83511 100644
> --- a/Documentation/devicetree/bindings/mtd/cadence-quadspi.txt
> +++ b/Documentation/devicetree/bindings/mtd/cadence-quadspi.txt
> @@ -2,6 +2,7 @@
>  
>  Required properties:
>  - compatible : Should be "cdns,qspi-nor".
> +	       Should be "ti,k2g-qspi" for TI 66AK2G platform.

Also, this doesn't indicate that "cdns,qspi-nor" is a fallback as you 
have in the dts files. Reformat to 1 valid combination per line.

>  - reg : Contains two entries, each of which is a tuple consisting of a
>  	physical address and length. The first entry is the address and
>  	length of the controller register set. The second entry is the