[PATCH 2/2] arm64: dts: apq8016-sbc: Correct WLAN LED default-trigger

[Bjorn Andersson]

The TX status trigger of the wlan interface is named phy0tx, so this
updates the default-trigger for the WLAN LED to use that instead.

Signed-off-by: Bjorn Andersson <bjorn.andersson at linaro.org>
---

Note that without patch 1/2 this trigger does not fire - but there's also no
harm in picking the two patches through separate trees.

 arch/arm64/boot/dts/qcom/apq8016-sbc.dtsi | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm64/boot/dts/qcom/apq8016-sbc.dtsi b/arch/arm64/boot/dts/qcom/apq8016-sbc.dtsi
index 5d83b02b7c4a..21a8f5ce8955 100644
--- a/arch/arm64/boot/dts/qcom/apq8016-sbc.dtsi
+++ b/arch/arm64/boot/dts/qcom/apq8016-sbc.dtsi
@@ -178,7 +178,7 @@
 			led at 5 {
 				label = "apq8016-sbc:yellow:wlan";
 				gpios = <&pm8916_mpps 2 GPIO_ACTIVE_HIGH>;
-				linux,default-trigger = "wlan";
+				linux,default-trigger = "phy0tx";
 				default-state = "off";
 			};
 
-- 
2.12.0