[PATCH v6 6/8] coresight: add support for CPU debug module

[Mathieu Poirier]

On 19 April 2017 at 09:30, Leo Yan <leo.yan at linaro.org> wrote:
> On Wed, Apr 19, 2017 at 08:52:12AM -0600, Mathieu Poirier wrote:
>
> [...]
>
>> >> > +static bool debug_enable;
>> >> > +module_param_named(enable, debug_enable, bool, 0600);
>> >> > +MODULE_PARM_DESC(enable, "Knob to enable debug functionality "
>> >> > +            "(default is 0, which means is disabled by default)");
>> >>
>> >> For this driver we have a debugFS interface so I question the validity of a
>> >> kernel module parameter.  Other than adding complexity to the code it offers no
>> >> real added value.  If a user is to insmod a module, it is just as easy to switch
>> >> on the functionality using debugFS in a second step.
>> >
>> > This module parameter can be used for kernel command line, so
>> > it's useful when user wants to dynamically turn on/off the
>> > functionality at boot up time.
>> >
>> > Does this make sense for you? Removing this parameter is okay for
>> > me, but this means users need to decide if use it by Kernel config
>> > with static building in. This is a bit contradictory with before's
>> > discussion.
>>
>> My hope was to use the kernel command line and the debugFS interface,
>> avoiding the module parameter.  Look at what the baycom_par and
>> blacklist drivers are doing with the "__setup()" function and see if
>> we can void a module parameter.  If not then let it be, unless someone
>> else has a better idea.
>>
>> [1]. drivers/net/hamradio/baycom_par.c
>> [2]. drivers/s390/cio/blacklist.c
>
> This driver supports module mode. So we can choose to use either module
> parameter or __setup(). But as described in the file
> Documentation/admin-guide/kernel-parameters.rst, the module parameter
> is more flexible to be used at boot time or insmod the module:
>
> "Parameters for modules which are built into the kernel need to be
> specified on the kernel command line.  modprobe looks through the
> kernel command line (/proc/cmdline) and collects module parameters
> when it loads a module, so the kernel command line can be used for
> loadable modules too."
>
> __setup() cannot support module mode, and when use __setup(), we need
> register one callback function for it. The callback function is
> friendly to parse complex parameters rather than module parameter.
> but it's not necessary for this case.

__setup() definitely supports module - the baycom driver is a good
example of that.

But as you pointed out kernel-parameters.rst is pretty clear on how to
proceed.  As such disregard my comment and proceed with a module
parameter.

>
> So I'm bias to use module parameter :)
>
> Thanks,
> Leo Yan