[PATCH] arm64/dts: fix legacy interrupt routing for AMD Seattle
Ard Biesheuvel
ard.biesheuvel at linaro.org
Fri Apr 7 07:17:33 EDT 2017
The Seattle SOC internally supports 3 PCIe slots, although only two
are wired up on the Overdrive board. For each of those slots, a bank
of four GIC interrupts is allocated, the legacy PCI interrupts INTA,
INTB, INTC and INTD.
So fix the interrupt-map property in the Seattle SOC DTS to reflect
this, and provide three separate mappings for the three bridge devices
connecting to each of the three slots.
Tested on Cello with the MSI bits removed from the DT. This board has
the following PCI topology
-[0000:00]-+-00.0 Advanced Micro Devices, Inc. [AMD] Device 1a00
+-02.0 Advanced Micro Devices, Inc. [AMD] Device 1a01
+-02.2-[01]----00.0 uPD720202 USB 3.0 Host Controller
\-02.3-[02]----00.0 Realtek R8169 PCIe Gigabit Ethernet Controller
and ends up using the following legacy interrupts with MSI disabled
36: GICv2 324 Edge PCIe PME, xhci-hcd:usb1
37: GICv2 328 Edge PCIe PME, enp2s0
Signed-off-by: Ard Biesheuvel <ard.biesheuvel at linaro.org>
---
arch/arm64/boot/dts/amd/amd-seattle-soc.dtsi | 23 +++++++++++++++-----
1 file changed, 18 insertions(+), 5 deletions(-)
diff --git a/arch/arm64/boot/dts/amd/amd-seattle-soc.dtsi b/arch/arm64/boot/dts/amd/amd-seattle-soc.dtsi
index bd3adeac374f..4679e4f2c985 100644
--- a/arch/arm64/boot/dts/amd/amd-seattle-soc.dtsi
+++ b/arch/arm64/boot/dts/amd/amd-seattle-soc.dtsi
@@ -212,12 +212,25 @@
msi-parent = <&v2m0>;
reg = <0 0xf0000000 0 0x10000000>;
- interrupt-map-mask = <0xf800 0x0 0x0 0x7>;
+ interrupt-map-mask = <0xff00 0x0 0x0 0x7>;
interrupt-map =
- <0x1000 0x0 0x0 0x1 &gic0 0x0 0x0 0x0 0x120 0x1>,
- <0x1000 0x0 0x0 0x2 &gic0 0x0 0x0 0x0 0x121 0x1>,
- <0x1000 0x0 0x0 0x3 &gic0 0x0 0x0 0x0 0x122 0x1>,
- <0x1000 0x0 0x0 0x4 &gic0 0x0 0x0 0x0 0x123 0x1>;
+ /* slot 1: dev 2 fn 1 */
+ <0x1100 0x0 0x0 0x1 &gic0 0x0 0x0 0x0 0x120 0x1>,
+ <0x1100 0x0 0x0 0x2 &gic0 0x0 0x0 0x0 0x121 0x1>,
+ <0x1100 0x0 0x0 0x3 &gic0 0x0 0x0 0x0 0x122 0x1>,
+ <0x1100 0x0 0x0 0x4 &gic0 0x0 0x0 0x0 0x123 0x1>,
+
+ /* slot 2: dev 2 fn 2 */
+ <0x1200 0x0 0x0 0x1 &gic0 0x0 0x0 0x0 0x124 0x1>,
+ <0x1200 0x0 0x0 0x2 &gic0 0x0 0x0 0x0 0x125 0x1>,
+ <0x1200 0x0 0x0 0x3 &gic0 0x0 0x0 0x0 0x126 0x1>,
+ <0x1200 0x0 0x0 0x4 &gic0 0x0 0x0 0x0 0x127 0x1>,
+
+ /* slot 3: dev 2 fn 3 */
+ <0x1300 0x0 0x0 0x1 &gic0 0x0 0x0 0x0 0x128 0x1>,
+ <0x1300 0x0 0x0 0x2 &gic0 0x0 0x0 0x0 0x129 0x1>,
+ <0x1300 0x0 0x0 0x3 &gic0 0x0 0x0 0x0 0x12a 0x1>,
+ <0x1300 0x0 0x0 0x4 &gic0 0x0 0x0 0x0 0x12b 0x1>;
dma-coherent;
dma-ranges = <0x43000000 0x0 0x0 0x0 0x0 0x100 0x0>;
--
2.9.3
More information about the linux-arm-kernel
mailing list