[PATCH v5 19/23] drivers/fsi: Add GPIO based FSI master

[Randy Dunlap]

On 04/04/17 19:06, Christopher Bostic wrote:
> From: Chris Bostic <cbostic at linux.vnet.ibm.com>
> 
> Implement a FSI master using GPIO.  Will generate FSI protocol for
> read and write commands to particular addresses.  Sends master command
> and waits for and decodes a slave response.
> 
> Includes changes from Edward A. James <eajames at us.ibm.com> and Jeremy
> Kerr <jk at ozlabs.org>.
> 
> Signed-off-by: Edward A. James <eajames at us.ibm.com>
> Signed-off-by: Jeremy Kerr <jk at ozlabs.org>
> Signed-off-by: Chris Bostic <cbostic at linux.vnet.ibm.com>
> Signed-off-by: Joel Stanley <joel at jms.id.au>
> ---
>  drivers/fsi/Kconfig           |  11 +
>  drivers/fsi/Makefile          |   1 +
>  drivers/fsi/fsi-master-gpio.c | 610 ++++++++++++++++++++++++++++++++++++++++++
>  3 files changed, 622 insertions(+)
>  create mode 100644 drivers/fsi/fsi-master-gpio.c
> 
> diff --git a/drivers/fsi/Kconfig b/drivers/fsi/Kconfig
> index 04c1a0e..9cf8345 100644
> --- a/drivers/fsi/Kconfig
> +++ b/drivers/fsi/Kconfig
> @@ -9,4 +9,15 @@ config FSI
>  	---help---
>  	  FSI - the FRU Support Interface - is a simple bus for low-level
>  	  access to POWER-based hardware.
> +
> +if FSI
> +
> +config FSI_MASTER_GPIO
> +	tristate "GPIO-based FSI master"
> +	depends on FSI && GPIOLIB

depends on FSI is redundant since "if FSI" does the same thing.

> +	---help---
> +	This option enables a FSI master driver using GPIO lines.
> +
> +endif
> +


-- 
~Randy