[PATCH v3 0/4] ARM: dts: sunxi: Add CAN node and can0_pins_a pinctrl settings

[Patrick Menschel]

The Allwinner A10/A20 SoCs have an on-board CAN (Controller Area Network)
controller. This patch adds the CAN core to the SoC's include files,
sun4i-a10.dtsi and sun7i-a20.dtsi.

On linux-can mailing list was a discussion about updating the device tree bindings
https://lkml.org/lkml/2015/9/17/220
but it did not progress past writing the documentation file.
Documentation/devicetree/bindings/net/can/sun4i_can.txt

The CAN controller can be enabled in a board specific dts file as
described in the documentation file or by using a device tree overlay.

I have tested the patch on a Banana Pi (A20 SoC) with mainline kernel 4.10.5.

History:
    v3: added "allwinner,sun7i-a20-can" compatible to can0 device node contents,
        make separate patches for device nodes and pinctrl settings

    v2: changed can0_pins_a node contents to new generic binding method, 
	changed can0_pins_a node position by alphabetical order,
        changed can0 device node position by rising physical address order

    v1: initial

Patrick Menschel (4):
  ARM: dts: sun4i: Add CAN node
  ARM: dts: sun4i: Add can0_pins_a pinctrl settings
  ARM: dts: sun7i: Add CAN node
  ARM: dts: sun7i: Add can0_pins_a pinctrl settings

 arch/arm/boot/dts/sun4i-a10.dtsi | 13 +++++++++++++
 arch/arm/boot/dts/sun7i-a20.dtsi | 14 ++++++++++++++
 2 files changed, 27 insertions(+)

-- 
1.9.1