[PATCH V2 1/7] dt-bindings: Update QorIQ TMU thermal bindings

[Zhang Rui]

On 三, 2016-09-14 at 11:40 -0500, Leo Li wrote:
> On Wed, Jun 8, 2016 at 2:52 PM, Rob Herring <robh at kernel.org> wrote:
> > 
> > On Tue, Jun 07, 2016 at 11:27:34AM +0800, Jia Hongtao wrote:
> > > 
> > > For different types of SoC the sensor id and endianness may vary.
> > > "#thermal-sensor-cells" is used to provide sensor id information.
> > > "little-endian" property is to tell the endianness of TMU.
> > > 
> > > Signed-off-by: Jia Hongtao <hongtao.jia at nxp.com>
> > > ---
> > > Changes for V2:
> > > * Remove formatting chnages.
> > > 
> > >  Documentation/devicetree/bindings/thermal/qoriq-thermal.txt | 7
> > > +++++++
> > >  1 file changed, 7 insertions(+)
> > Acked-by: Rob Herring <robh at kernel.org>
> Hi Zhang Rui,
> 
> Since you have applied the driver patch, can you also apply the
> binding patch?  The binding is supposed to go with the driver.
> 

Do you mean I should take both patch 1/7 and 7/7? I can not see the
other patches in this patch set.

thanks,
rui