[PATCH v2 6/6] ARM64: meson-gxbb-vega-s95: Enable USB Nodes

Martin Blumenstingl martin.blumenstingl at googlemail.com
Sun Sep 11 06:41:11 PDT 2016


Enable both gxbb USB controller and add a 5V regulator for the OTG port
VBUS

Signed-off-by: Martin Blumenstingl <martin.blumenstingl at googlemail.com>
Signed-off-by: Jerome Brunet <jbrunet at baylibre.com>
---
 .../boot/dts/amlogic/meson-gxbb-vega-s95.dtsi      | 30 ++++++++++++++++++++++
 1 file changed, 30 insertions(+)

diff --git a/arch/arm64/boot/dts/amlogic/meson-gxbb-vega-s95.dtsi b/arch/arm64/boot/dts/amlogic/meson-gxbb-vega-s95.dtsi
index 463185d..bad32e6 100644
--- a/arch/arm64/boot/dts/amlogic/meson-gxbb-vega-s95.dtsi
+++ b/arch/arm64/boot/dts/amlogic/meson-gxbb-vega-s95.dtsi
@@ -77,6 +77,19 @@
 		compatible = "mmc-pwrseq-emmc";
 		reset-gpios = <&gpio BOOT_9 GPIO_ACTIVE_LOW>;
 	};
+
+	usb_vbus: regulator-usb0-vbus {
+		compatible = "regulator-fixed";
+
+		regulator-name = "USB0_VBUS";
+
+		regulator-min-microvolt = <5000000>;
+		regulator-max-microvolt = <5000000>;
+
+		gpio = <&gpio GPIODV_24 GPIO_ACTIVE_HIGH>;
+		enable-active-high;
+	};
+
 };
 
 &uart_AO {
@@ -133,3 +146,20 @@
 	vmmc-supply = <&vcc_3v3>;
 	vmmcq-sumpply = <&vcc_1v8>;
 };
+
+&usb0_phy {
+	status = "okay";
+	phy-supply = <&usb_vbus>;
+};
+
+&usb1_phy {
+	status = "okay";
+};
+
+&usb0 {
+	status = "okay";
+};
+
+&usb1 {
+	status = "okay";
+};
-- 
2.9.3




More information about the linux-arm-kernel mailing list