[RESEND PATCH] ARM: dts: lpc32xx: set default parent clock for pwm1 & pwm2

[Sylvain Lemieux]

On Thu, 2016-09-08 at 02:46 +0300, Vladimir Zapolskiy wrote:
> Hi Sylvain,
> 
> On 07.09.2016 22:37, Sylvain Lemieux wrote:
> > From: Sylvain Lemieux <slemieux at tycoint.com>
> >
> > The change setup the peripheral clock (PERIPH_CLK) as the default
> > parent clock for PWM1 & PWM2.
> >
> > Signed-off-by: Sylvain Lemieux <slemieux at tycoint.com>
> > ---
> >  arch/arm/boot/dts/lpc32xx.dtsi | 6 ++++++
> >  1 file changed, 6 insertions(+)
> >
> > diff --git a/arch/arm/boot/dts/lpc32xx.dtsi
> > b/arch/arm/boot/dts/lpc32xx.dtsi index e295e1e..ed85b95 100644
> > --- a/arch/arm/boot/dts/lpc32xx.dtsi
> > +++ b/arch/arm/boot/dts/lpc32xx.dtsi
> > @@ -469,6 +469,9 @@
> >  				compatible = "nxp,lpc3220-pwm";
> >  				reg = <0x4005C000 0x4>;
> >  				clocks = <&clk LPC32XX_CLK_PWM1>;
> > +				assigned-clocks = <&clk LPC32XX_CLK_PWM1>,
> > +						  <&clk LPC32XX_CLK_PERIPH>;
> 
> I believe here "assigned-clocks = <&clk LPC32XX_CLK_PWM1>;" would be good
> enough. In this context the second clock could be potentially specified,
if you
> are going to set its rate, but because it is a common clock for many
controllers it
> should not be done from a PWM device node.
> 
Good catch!
Thanks for the feedback; I will submit a version 2 of the patch.

> > +				assigned-clock-parents = <&clk
> LPC32XX_CLK_PERIPH>;
> >  				status = "disabled";
> >  			};
> >
> > @@ -476,6 +479,9 @@
> >  				compatible = "nxp,lpc3220-pwm";
> >  				reg = <0x4005C004 0x4>;
> >  				clocks = <&clk LPC32XX_CLK_PWM2>;
> > +				assigned-clocks = <&clk LPC32XX_CLK_PWM2>,
> > +						  <&clk LPC32XX_CLK_PERIPH>;
> 
> Same as above.
> 
> Please remove the second <&clk LPC32XX_CLK_PERIPH> value from the
> assigned-clocks property.
> 
> > +				assigned-clock-parents = <&clk
> LPC32XX_CLK_PERIPH>;
> >  				status = "disabled";
> >  			};
> >
> >
> 
> --
> With best wishes,
> Vladimir