[PATCH 1/2] ARM: dts: fix RealView EB SMSC ethernet version

[Linus Walleij]

The ethernet version in the earlier RealView EB variants is
LAN91C111 and not LAN9118 according to ARM DUI 0303E
"RealView Emulation Baseboard User Guide" page 3-57.

Make sure that this is used for the base variant of the board.

As the DT bindings for LAN91C111 does not specify any power
supplies, these need to be deleted from the DTS file.

Fixes: 2440d29d2ae2 ("ARM: dts: realview: support all the RealView EB board variants")
Signed-off-by: Linus Walleij <linus.walleij at linaro.org>
---
ARM SoC people: please apply this directly with the second patch.
---
 arch/arm/boot/dts/arm-realview-eb.dtsi | 17 ++---------------
 1 file changed, 2 insertions(+), 15 deletions(-)

diff --git a/arch/arm/boot/dts/arm-realview-eb.dtsi b/arch/arm/boot/dts/arm-realview-eb.dtsi
index 1c6a040218e3..22f6a4f201b7 100644
--- a/arch/arm/boot/dts/arm-realview-eb.dtsi
+++ b/arch/arm/boot/dts/arm-realview-eb.dtsi
@@ -51,14 +51,6 @@
 		regulator-boot-on;
         };
 
-	veth: fixedregulator at 0 {
-		compatible = "regulator-fixed";
-		regulator-name = "veth";
-		regulator-min-microvolt = <3300000>;
-		regulator-max-microvolt = <3300000>;
-		regulator-boot-on;
-	};
-
 	xtal24mhz: xtal24mhz at 24M {
 		#clock-cells = <0>;
 		compatible = "fixed-clock";
@@ -134,16 +126,11 @@
 		bank-width = <4>;
 	};
 
-	/* SMSC 9118 ethernet with PHY and EEPROM */
+	/* SMSC LAN91C111 ethernet with PHY and EEPROM */
 	ethernet: ethernet at 4e000000 {
-		compatible = "smsc,lan9118", "smsc,lan9115";
+		compatible = "smsc,lan91c111";
 		reg = <0x4e000000 0x10000>;
-		phy-mode = "mii";
 		reg-io-width = <4>;
-		smsc,irq-active-high;
-		smsc,irq-push-pull;
-		vdd33a-supply = <&veth>;
-		vddvario-supply = <&veth>;
 	};
 
 	usb: usb at 4f000000 {
-- 
2.7.4