[PATCH v4 6/8] dts: sun8i-h3: associate pinmux/peripherals for UART2-3

[jorik at kippendief.biz]

From: Jorik Jonker <jorik at kippendief.biz>

Although these peripherals are disabled, they are associated to the
pinmux definitions. Again, these are the full pinmux defs which include
RTS/CTS. One could narrow this down to RX/TX only in a board specific
DTS.

Signed-off-by: Jorik Jonker <jorik at kippendief.biz>
---
 arch/arm/boot/dts/sun8i-h3.dtsi | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/arch/arm/boot/dts/sun8i-h3.dtsi b/arch/arm/boot/dts/sun8i-h3.dtsi
index 5cde54c..e9528d1 100644
--- a/arch/arm/boot/dts/sun8i-h3.dtsi
+++ b/arch/arm/boot/dts/sun8i-h3.dtsi
@@ -443,6 +443,8 @@
 			resets = <&ccu RST_BUS_UART2>;
 			dmas = <&dma 8>, <&dma 8>;
 			dma-names = "rx", "tx";
+			pinctrl-names = "default";
+			pinctrl-0 = <&uart2_rts_cts_pins>;
 			status = "disabled";
 		};
 
@@ -456,6 +458,8 @@
 			resets = <&ccu RST_BUS_UART3>;
 			dmas = <&dma 9>, <&dma 9>;
 			dma-names = "rx", "tx";
+			pinctrl-names = "default";
+			pinctrl-0 = <&uart3_rts_cts_pins>;
 			status = "disabled";
 		};
 
-- 
2.7.4