[PATCH v2 5/5] fpga manager: cyclone-ps-spi: make delay variable
Joshua Clayton
stillcompiling at gmail.com
Fri Oct 28 09:56:42 PDT 2016
The status pin may not show ready in the time described in the
Altetera manual. check the value several times before giving up
For the hardware I am working on, the status pin takes 250 us,
5 times as long as described by Altera.
Signed-off-by: Joshua Clayton <stillcompiling at gmail.com>
---
drivers/fpga/cyclone-ps-spi.c | 13 ++++++++-----
1 file changed, 8 insertions(+), 5 deletions(-)
diff --git a/drivers/fpga/cyclone-ps-spi.c b/drivers/fpga/cyclone-ps-spi.c
index 4b70d5c..c368223 100644
--- a/drivers/fpga/cyclone-ps-spi.c
+++ b/drivers/fpga/cyclone-ps-spi.c
@@ -20,6 +20,7 @@
#define FPGA_RESET_TIME 50 /* time in usecs to trigger FPGA config */
-#define FPGA_MIN_DELAY 250 /* min usecs to wait for config status */
+#define FPGA_MIN_DELAY 50 /* min usecs to wait for config status */
+#define FPGA_MAX_DELAY 1000 /* max usecs to wait for config status */
struct cyclonespi_conf {
struct gpio_desc *config;
@@ -42,6 +43,7 @@ static int cyclonespi_write_init(struct fpga_manager *mgr, u32 flags,
const char *buf, size_t count)
{
struct cyclonespi_conf *conf = (struct cyclonespi_conf *)mgr->priv;
+ int i;
if (flags & FPGA_MGR_PARTIAL_RECONFIG) {
dev_err(&mgr->dev, "Partial reconfiguration not supported.\n");
@@ -56,13 +58,14 @@ static int cyclonespi_write_init(struct fpga_manager *mgr, u32 flags,
}
gpiod_set_value(conf->config, 1);
- usleep_range(FPGA_MIN_DELAY, FPGA_MIN_DELAY + 20);
- if (gpiod_get_value(conf->status) == 0) {
- dev_err(&mgr->dev, "Status pin not ready.\n");
- return -EIO;
+ for (i = 0; i < (FPGA_MAX_DELAY / FPGA_MIN_DELAY); i++) {
+ usleep_range(FPGA_MIN_DELAY, FPGA_MIN_DELAY + 20);
+ if (gpiod_get_value(conf->status))
+ return 0;
}
- return 0;
+ dev_err(&mgr->dev, "Status pin not ready.\n");
+ return -EIO;
}
static void rev_buf(void *buf, size_t len)
--
2.7.4
More information about the linux-arm-kernel
mailing list