[PATCH V3 1/6] clk: tegra: add TEGRA20_CLK_NOR to init table

[Mirza Krak]

From: Mirza Krak <mirza.krak at gmail.com>

Add TEGRA20_CLK_NOR to init table and set default rate to 92 MHz which
is max rate.

The maximum rate value of 92 MHz is pulled from the downstream L4T
kernel.

Signed-off-by: Mirza Krak <mirza.krak at gmail.com>
Tested-by: Marcel Ziswiler <marcel.ziswiler at toradex.com>
Tested-on: Colibri T20/T30 on EvalBoard V3.x and GMI-Memory Board
---

Changes in v2:
- no changes

Changes in v3:
- Added comment in commit message where I got the maximum rates from.

 drivers/clk/tegra/clk-tegra20.c | 1 +
 1 file changed, 1 insertion(+)

diff --git a/drivers/clk/tegra/clk-tegra20.c b/drivers/clk/tegra/clk-tegra20.c
index 837e5cb..13d3b5a 100644
--- a/drivers/clk/tegra/clk-tegra20.c
+++ b/drivers/clk/tegra/clk-tegra20.c
@@ -1047,6 +1047,7 @@ static struct tegra_clk_init_table init_table[] __initdata = {
 	{ TEGRA20_CLK_SDMMC3, TEGRA20_CLK_PLL_P, 48000000, 0 },
 	{ TEGRA20_CLK_SDMMC4, TEGRA20_CLK_PLL_P, 48000000, 0 },
 	{ TEGRA20_CLK_SPI, TEGRA20_CLK_PLL_P, 20000000, 0 },
+	{ TEGRA20_CLK_NOR, TEGRA20_CLK_PLL_P, 92000000, 0 },
 	{ TEGRA20_CLK_SBC1, TEGRA20_CLK_PLL_P, 100000000, 0 },
 	{ TEGRA20_CLK_SBC2, TEGRA20_CLK_PLL_P, 100000000, 0 },
 	{ TEGRA20_CLK_SBC3, TEGRA20_CLK_PLL_P, 100000000, 0 },
--
2.1.4