[PATCH 2/5] Documentation: devicetree: net: add NS2 bindings to amac

[Andrew Lunn]

On Wed, Oct 26, 2016 at 03:35:58PM -0400, Jon Mason wrote:
> Signed-off-by: Jon Mason <jon.mason at broadcom.com>
> ---
>  Documentation/devicetree/bindings/net/brcm,amac.txt | 7 +++++--
>  1 file changed, 5 insertions(+), 2 deletions(-)
> 
> diff --git a/Documentation/devicetree/bindings/net/brcm,amac.txt b/Documentation/devicetree/bindings/net/brcm,amac.txt
> index ba5ecc1..f92caee 100644
> --- a/Documentation/devicetree/bindings/net/brcm,amac.txt
> +++ b/Documentation/devicetree/bindings/net/brcm,amac.txt
> @@ -2,15 +2,18 @@ Broadcom AMAC Ethernet Controller Device Tree Bindings
>  -------------------------------------------------------------
>  
>  Required properties:
> - - compatible:	"brcm,amac" or "brcm,nsp-amac"
> + - compatible:	"brcm,amac", "brcm,nsp-amac", or "brcm,ns2-amac"
>   - reg:		Address and length of the GMAC registers,
>  		Address and length of the GMAC IDM registers
> +		Address and length of the NIC Port Manager registers (optional)
>   - reg-names:	Names of the registers.  Must have both "amac_base" and
> -		"idm_base"
> +		"idm_base". "nicpm_base" is optional (required for NS2)
>   - interrupts:	Interrupt number
>  
>  Optional properties:
>  - mac-address:	See ethernet.txt file in the same directory
> +- brcm,enet-phy-lane-swap:
> +		boolean; Swap the PHY lanes (needed on some SKUs of NS2)

Maybe i'm missing something here, but the patch to the PHY swapped the
lanes. This seems to be a PHY property, not a MAC property. And it
swapped them unconditionally....

	Andrew