[PATCH 0/5] ADD STM32F746 MCU and STM32746G-Eval board supports
Alexandre TORGUE
alexandre.torgue at st.com
Wed Oct 26 08:11:18 PDT 2016
This series adds basic support for STM32F746 MCU and stm32746g-eval board.
With it, you can boot stm32746g-eval board successfully.
In this series timer, usart/uart, exti, rng, basic rcc IPs are supported.
Other Ips (Ethernet, dma, ...) will come later.
For your information:
The STMicrolectornics's STM32F746 MCU has the following main features:
- Cortex-M7 core running up to @216MHz
- 1MB internal flash, 320KBytes internal RAM (+4KB of backup SRAM)
- FMC controller to connect SDRAM, NOR and NAND memories
- Dual mode QSPI
- SD/MMC/SDIO support
- Ethernet controller
- USB OTFG FS & HS controllers
- I2C, SPI, CAN busses support
- Several 16 & 32 bits general purpose timers
- Serial Audio interface
- LCD controller
- HDMI-CEC
- SPDIFRX
Regards
Alex
Alexandre TORGUE (5):
ARM: mach-stm32: Add a new SOC - STM32F746
ARM: Kconfig: Introduce MACH_STM32F746 flag
ARM: dts: Add STM32F746 MCU and STM32746g-EVAL board
ARM: configs: Add new config fragment to change RAM start point
ARM: configs: Add new config fragment to change RAM size
Documentation/arm/stm32/overview.txt | 3 +-
Documentation/arm/stm32/stm32f746-overview.txt | 34 +++
arch/arm/Kconfig | 5 +
arch/arm/boot/dts/Makefile | 3 +-
arch/arm/boot/dts/stm32746g-eval.dts | 96 ++++++++
arch/arm/boot/dts/stm32f746.dtsi | 304 +++++++++++++++++++++++++
arch/arm/configs/dram_0xc0000000.config | 1 +
arch/arm/configs/dram_size_0x2000000.config | 1 +
arch/arm/mach-stm32/board-dt.c | 1 +
9 files changed, 446 insertions(+), 2 deletions(-)
create mode 100644 Documentation/arm/stm32/stm32f746-overview.txt
create mode 100644 arch/arm/boot/dts/stm32746g-eval.dts
create mode 100644 arch/arm/boot/dts/stm32f746.dtsi
create mode 100644 arch/arm/configs/dram_0xc0000000.config
create mode 100644 arch/arm/configs/dram_size_0x2000000.config
--
1.9.1
More information about the linux-arm-kernel
mailing list