[PATCH 3/5] ARM: dts: imx6qdl-sabrelite: add missing USB PHY reset control

[Gary Bisson]

Declared as a regulator since the driver doesn't have a reset-gpios
property for this.

This ensures that the PHY is woken up, not depending on the state the
second stage bootloader leaves the pin.

Signed-off-by: Gary Bisson <gary.bisson at boundarydevices.com>
---
 arch/arm/boot/dts/imx6qdl-sabrelite.dtsi | 20 ++++++++++++++++++++
 1 file changed, 20 insertions(+)

diff --git a/arch/arm/boot/dts/imx6qdl-sabrelite.dtsi b/arch/arm/boot/dts/imx6qdl-sabrelite.dtsi
index cebea8a..bf00267 100644
--- a/arch/arm/boot/dts/imx6qdl-sabrelite.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-sabrelite.dtsi
@@ -94,6 +94,19 @@
 			pinctrl-0 = <&pinctrl_can_xcvr>;
 			gpio = <&gpio1 2 GPIO_ACTIVE_LOW>;
 		};
+
+		reg_usb_h1_vbus: regulator at 4 {
+			compatible = "regulator-fixed";
+			reg = <4>;
+			pinctrl-names = "default";
+			pinctrl-0 = <&pinctrl_usbh1>;
+			regulator-name = "usb_h1_vbus";
+			regulator-min-microvolt = <3300000>;
+			regulator-max-microvolt = <3300000>;
+			gpio = <&gpio7 12 GPIO_ACTIVE_HIGH>;
+			enable-active-high;
+			regulator-always-on;
+		};
 	};
 
 	gpio-keys {
@@ -481,6 +494,12 @@
 			>;
 		};
 
+		pinctrl_usbh1: usbh1grp {
+			fsl,pins = <
+				MX6QDL_PAD_GPIO_17__GPIO7_IO12		0x030b0
+			>;
+		};
+
 		pinctrl_usbotg: usbotggrp {
 			fsl,pins = <
 				MX6QDL_PAD_GPIO_1__USB_OTG_ID		0x17059
@@ -578,6 +597,7 @@
 };
 
 &usbh1 {
+	vbus-supply = <&reg_usb_h1_vbus>;
 	status = "okay";
 };
 
-- 
2.9.3