[PATCH] i2c: rk3x: Give the tuning value 0 during rk3x_i2c_v0_calc_timings
Andy Yan
andy.yan at rock-chips.com
Mon Oct 24 04:55:32 PDT 2016
Hi:
On 2016年10月22日 16:43, David Wu wrote:
> We found a bug that i2c transfer sometimes failed on 3066a board with
> stabel-4.8, the con register would be updated by uninitialized tuning
> value, it made the i2c transfer failed.
>
> So give the tuning value to be zero during rk3x_i2c_v0_calc_timings.
>
> Signed-off-by: David Wu <david.wu at rock-chips.com>
> ---
> drivers/i2c/busses/i2c-rk3x.c | 2 ++
> 1 file changed, 2 insertions(+)
>
> diff --git a/drivers/i2c/busses/i2c-rk3x.c b/drivers/i2c/busses/i2c-rk3x.c
> index 50702c7..df22066 100644
> --- a/drivers/i2c/busses/i2c-rk3x.c
> +++ b/drivers/i2c/busses/i2c-rk3x.c
> @@ -694,6 +694,8 @@ static int rk3x_i2c_v0_calc_timings(unsigned long clk_rate,
> t_calc->div_low--;
> t_calc->div_high--;
>
> + /* Give the tuning value 0, that would not update con register */
> + t_calc->tuning = 0;
> /* Maximum divider supported by hw is 0xffff */
> if (t_calc->div_low > 0xffff) {
> t_calc->div_low = 0xffff;
rk3066a based board can't boot up(with endless i2c irq messages print
out) from linux-4.8 without this fix.
Tested-by: Andy Yan <andy.yan at rock-chips.com>
More information about the linux-arm-kernel
mailing list