[PATCH] ARM: sti: stih407-clocks: Identify critical clocks
Patrice Chotard
patrice.chotard at st.com
Fri Oct 21 05:17:27 PDT 2016
On 10/21/2016 11:08 AM, Peter Griffin wrote:
> Lots of platforms contain clocks which if turned off would prove fatal.
> The only way to recover is to restart the board(s). This driver takes
> references to clocks which are required to be always-on. The Common
> Clk Framework will then take references to them. This way they will
> not be turned off during the clk_disabled_unused() procedure.
>
> In this patch we are identifying clocks, which if gated would render
> the STiH407 development board unserviceable.
>
> Signed-off-by: Peter Griffin <peter.griffin at linaro.org>
> ---
> arch/arm/boot/dts/stih407-clock.dtsi | 10 ++++++++++
> 1 file changed, 10 insertions(+)
>
> diff --git a/arch/arm/boot/dts/stih407-clock.dtsi b/arch/arm/boot/dts/stih407-clock.dtsi
> index 13029c0..34c119a 100644
> --- a/arch/arm/boot/dts/stih407-clock.dtsi
> +++ b/arch/arm/boot/dts/stih407-clock.dtsi
> @@ -101,6 +101,7 @@
> clocks = <&clk_sysin>;
>
> clock-output-names = "clk-s-a0-pll-ofd-0";
> + clock-critical = <0>; /* clk-s-a0-pll-ofd-0 */
> };
>
> clk_s_a0_flexgen: clk-s-a0-flexgen {
> @@ -112,6 +113,7 @@
> <&clk_sysin>;
>
> clock-output-names = "clk-ic-lmi0";
> + clock-critical = <CLK_IC_LMI0>;
> };
> };
>
> @@ -126,6 +128,7 @@
> "clk-s-c0-fs0-ch1",
> "clk-s-c0-fs0-ch2",
> "clk-s-c0-fs0-ch3";
> + clock-critical = <0>; /* clk-s-c0-fs0-ch0 */
> };
>
> clk_s_c0: clockgen-c at 09103000 {
> @@ -139,6 +142,7 @@
> clocks = <&clk_sysin>;
>
> clock-output-names = "clk-s-c0-pll0-odf-0";
> + clock-critical = <0>; /* clk-s-c0-pll0-odf-0 */
> };
>
> clk_s_c0_pll1: clk-s-c0-pll1 {
> @@ -194,6 +198,12 @@
> "clk-main-disp",
> "clk-aux-disp",
> "clk-compo-dvp";
> + clock-critical = <CLK_PROC_STFE>,
> + <CLK_ICN_CPU>,
> + <CLK_TX_ICN_DMU>,
> + <CLK_EXT2F_A9>,
> + <CLK_ICN_LMI>,
> + <CLK_ICN_SBC>;
> };
> };
>
>
Acked-by: Patrice Chotard <patrice.chotard at st.com>
And applied !
Effectively, the job was done for STiH410 but i forgot to apply the same for STiH407
Thanks Peter ;-)
More information about the linux-arm-kernel
mailing list