[PATCH v2 2/4] ARM: dts: pxa: add pxa25x cpu operating points

[Viresh Kumar]

On 18-10-16, 17:30, Robert Jarzmik wrote:
> Viresh Kumar <viresh.kumar at linaro.org> writes:
> 
> > On 15-10-16, 21:57, Robert Jarzmik wrote:
> >> Add the relevant data taken from the PXA 25x Electrical, Mechanical, and
> >> Thermal Specfication. This will be input data for cpufreq-dt driver.
> >> 
> >> Signed-off-by: Robert Jarzmik <robert.jarzmik at free.fr>
> >> ---
> >>  arch/arm/boot/dts/pxa25x.dtsi | 25 +++++++++++++++++++++++++
> >>  1 file changed, 25 insertions(+)
> >> 
> >> diff --git a/arch/arm/boot/dts/pxa25x.dtsi b/arch/arm/boot/dts/pxa25x.dtsi
> >> index 0d1e012178c4..16b4e8bad4a5 100644
> >> --- a/arch/arm/boot/dts/pxa25x.dtsi
> >> +++ b/arch/arm/boot/dts/pxa25x.dtsi
> >> @@ -89,4 +89,29 @@
> >>  		clocks = <&clktimer>;
> >>  		status = "okay";
> >>  	};
> >> +
> >> +	pxa250_opp_table: opp_table0 {
> >> +		compatible = "operating-points-v2";
> >> +
> >> +		opp at 99500 {
> >
> > We have been keeping the values in ^^^ same as the values present
> > below. Any specific reason for making it different here ?
> No, that's a good comment, I'll change that.
> 
> I wrote this incrementaly, first the node, then the opp-hz. Then I realized that
> the source crystal, at 3.8684 MHz didn't provide a round 99.5 MHz core clock,
> but a 99.5328 MHz clock.
> 
> Anyway, I'll change that ... let's say into opp at 99533 in this case ?

Just write the whole value 99532800.

-- 
viresh