[PATCH v9 2/2] ARM: dts: add TOPEET itop elite based board

[Krzysztof Kozlowski]

On Tue, Oct 18, 2016 at 8:47 PM, Krzysztof Kozlowski <krzk at kernel.org> wrote:
> On Tue, Oct 18, 2016 at 08:37:48PM +0300, Krzysztof Kozlowski wrote:
>> On Wed, Oct 19, 2016 at 01:18:49AM +0800, Randy Li wrote:
>> > The TOPEET itop exynos 4412 have three versions base board. The
>> > Elite version is the cheap one without too much peripheral devices
>> > on it.
>> >
>> > Currently supported are serial console, wired networking(USB),
>> > USB OTG in peripheral mode, USB host, SD storage, GPIO buttons,
>> > PWM beeper, ADC and LEDs. The WM8960 analog audio codec is also
>> > enabled.
>> >
>> > The FIMC is not used for camera currently, I enabled it just for a
>> > colorspace converter.
>> >
>> > Signed-off-by: Randy Li <ayaka at soulik.info>
>> > Reviewed-by: Krzysztof Kozlowski <krzk at kernel.org>
>>
>> Thanks, applied, with missing Rob's ack, minor changes in commit msg and
>> fix in pin function (you used macro for pull up/down instead of
>> function).
>
> I also changed your name in commit message from "ayaka" to "Randy Li".
> The author of a patch (equal to "From:" in email) should match the
> Signed-off-by. For the future, please fix your gitconfig and/or mail
> transfer program.

Ahhh, it is not your fault but patchwork's. Damn it. Patchwork stores
the first username he encounters and uses it further even if From is
different.

I will send an email to kernel.org Patchwork admin about this.

Best regards,
Krzysztof