[PATCH v5 20/23] usb: chipidea: msm: Handle phy power states
Stephen Boyd
stephen.boyd at linaro.org
Mon Oct 17 18:56:33 PDT 2016
The ULPI phy on qcom platforms needs to be initialized and
powered on after a USB reset and before we toggle the run/stop
bit. Otherwise, the phy locks up and doesn't work properly. Hook
the phy initialization into the RESET event and the phy power off
into the STOPPED event.
Acked-by: Peter Chen <peter.chen at nxp.com>
Cc: Greg Kroah-Hartman <gregkh at linuxfoundation.org>
Signed-off-by: Stephen Boyd <stephen.boyd at linaro.org>
---
drivers/usb/chipidea/ci_hdrc_msm.c | 40 +++++++++++++++++++-------------------
drivers/usb/chipidea/core.c | 8 ++++++--
drivers/usb/chipidea/host.c | 8 ++++++--
include/linux/usb/chipidea.h | 2 +-
4 files changed, 33 insertions(+), 25 deletions(-)
diff --git a/drivers/usb/chipidea/ci_hdrc_msm.c b/drivers/usb/chipidea/ci_hdrc_msm.c
index fe96df7b530c..316044dba0ac 100644
--- a/drivers/usb/chipidea/ci_hdrc_msm.c
+++ b/drivers/usb/chipidea/ci_hdrc_msm.c
@@ -80,20 +80,33 @@ static const struct reset_control_ops ci_hdrc_msm_reset_ops = {
.reset = ci_hdrc_msm_por_reset,
};
-static void ci_hdrc_msm_notify_event(struct ci_hdrc *ci, unsigned event)
+static int ci_hdrc_msm_notify_event(struct ci_hdrc *ci, unsigned event)
{
struct device *dev = ci->dev->parent;
struct ci_hdrc_msm *msm_ci = dev_get_drvdata(dev);
+ int ret;
switch (event) {
case CI_HDRC_CONTROLLER_RESET_EVENT:
dev_dbg(dev, "CI_HDRC_CONTROLLER_RESET_EVENT received\n");
+
+ hw_phymode_configure(ci);
if (msm_ci->secondary_phy) {
u32 val = readl_relaxed(msm_ci->base + HS_PHY_SEC_CTRL);
val |= HS_PHY_DIG_CLAMP_N;
writel_relaxed(val, msm_ci->base + HS_PHY_SEC_CTRL);
}
+ ret = phy_init(ci->phy);
+ if (ret)
+ return ret;
+
+ ret = phy_power_on(ci->phy);
+ if (ret) {
+ phy_exit(ci->phy);
+ return ret;
+ }
+
/* use AHB transactor, allow posted data writes */
hw_write_id_reg(ci, HS_PHY_AHB_MODE, 0xffffffff, 0x8);
@@ -113,21 +126,18 @@ static void ci_hdrc_msm_notify_event(struct ci_hdrc *ci, unsigned event)
HSPHY_SESS_VLD_CTRL);
}
-
- usb_phy_init(ci->usb_phy);
break;
case CI_HDRC_CONTROLLER_STOPPED_EVENT:
dev_dbg(dev, "CI_HDRC_CONTROLLER_STOPPED_EVENT received\n");
- /*
- * Put the phy in non-driving mode. Otherwise host
- * may not detect soft-disconnection.
- */
- usb_phy_notify_disconnect(ci->usb_phy, USB_SPEED_UNKNOWN);
+ phy_power_off(ci->phy);
+ phy_exit(ci->phy);
break;
default:
dev_dbg(dev, "unknown ci_hdrc event\n");
break;
}
+
+ return 0;
}
static int ci_hdrc_msm_mux_phy(struct ci_hdrc_msm *ci,
@@ -167,7 +177,6 @@ static int ci_hdrc_msm_probe(struct platform_device *pdev)
{
struct ci_hdrc_msm *ci;
struct platform_device *plat_ci;
- struct usb_phy *phy;
struct clk *clk;
struct reset_control *reset;
struct resource *res;
@@ -181,21 +190,12 @@ static int ci_hdrc_msm_probe(struct platform_device *pdev)
return -ENOMEM;
platform_set_drvdata(pdev, ci);
- /*
- * OTG(PHY) driver takes care of PHY initialization, clock management,
- * powering up VBUS, mapping of registers address space and power
- * management.
- */
- phy = devm_usb_get_phy_by_phandle(&pdev->dev, "usb-phy", 0);
- if (IS_ERR(phy))
- return PTR_ERR(phy);
-
ci->pdata.name = "ci_hdrc_msm";
ci->pdata.capoffset = DEF_CAPOFFSET;
ci->pdata.flags = CI_HDRC_REGS_SHARED | CI_HDRC_DISABLE_STREAMING |
- CI_HDRC_OVERRIDE_AHB_BURST;
+ CI_HDRC_OVERRIDE_AHB_BURST |
+ CI_HDRC_OVERRIDE_PHY_CONTROL;
ci->pdata.notify_event = ci_hdrc_msm_notify_event;
- ci->pdata.usb_phy = phy;
reset = devm_reset_control_get(&pdev->dev, "core");
if (IS_ERR(reset))
diff --git a/drivers/usb/chipidea/core.c b/drivers/usb/chipidea/core.c
index d1ae9a03e0fa..fbef1c961572 100644
--- a/drivers/usb/chipidea/core.c
+++ b/drivers/usb/chipidea/core.c
@@ -327,6 +327,7 @@ void hw_phymode_configure(struct ci_hdrc *ci)
hw_write(ci, OP_PORTSC, PORTSC_STS, PORTSC_STS);
}
}
+EXPORT_SYMBOL_GPL(hw_phymode_configure);
/**
* _ci_usb_phy_init: initialize phy taking in account both phy and usb_phy
@@ -503,9 +504,12 @@ int hw_device_reset(struct ci_hdrc *ci)
return ret;
}
- if (ci->platdata->notify_event)
- ci->platdata->notify_event(ci,
+ if (ci->platdata->notify_event) {
+ ret = ci->platdata->notify_event(ci,
CI_HDRC_CONTROLLER_RESET_EVENT);
+ if (ret)
+ return ret;
+ }
/* USBMODE should be configured step by step */
hw_write(ci, OP_USBMODE, USBMODE_CM, USBMODE_CM_IDLE);
diff --git a/drivers/usb/chipidea/host.c b/drivers/usb/chipidea/host.c
index f036a9e39ced..bbfb9e62d49d 100644
--- a/drivers/usb/chipidea/host.c
+++ b/drivers/usb/chipidea/host.c
@@ -90,8 +90,12 @@ static int ehci_ci_reset(struct usb_hcd *hcd)
ehci->need_io_watchdog = 0;
- if (ci->platdata->notify_event)
- ci->platdata->notify_event(ci, CI_HDRC_CONTROLLER_RESET_EVENT);
+ if (ci->platdata->notify_event) {
+ ret = ci->platdata->notify_event(ci,
+ CI_HDRC_CONTROLLER_RESET_EVENT);
+ if (ret)
+ return ret;
+ }
ci_platform_configure(ci);
diff --git a/include/linux/usb/chipidea.h b/include/linux/usb/chipidea.h
index 7e3daa37cf60..c5fdfcf99828 100644
--- a/include/linux/usb/chipidea.h
+++ b/include/linux/usb/chipidea.h
@@ -61,7 +61,7 @@ struct ci_hdrc_platform_data {
enum usb_dr_mode dr_mode;
#define CI_HDRC_CONTROLLER_RESET_EVENT 0
#define CI_HDRC_CONTROLLER_STOPPED_EVENT 1
- void (*notify_event) (struct ci_hdrc *ci, unsigned event);
+ int (*notify_event) (struct ci_hdrc *ci, unsigned event);
struct regulator *reg_vbus;
struct usb_otg_caps ci_otg_caps;
bool tpl_support;
--
2.10.0.297.gf6727b0
More information about the linux-arm-kernel
mailing list