[PATCH v15 1/4] dt-bindings: soc: Add documentation for the MediaTek GCE unit
HS Liao
hs.liao at mediatek.com
Mon Oct 17 03:11:54 PDT 2016
This adds documentation for the MediaTek Global Command Engine (GCE) unit
found in MT8173 SoCs.
Signed-off-by: HS Liao <hs.liao at mediatek.com>
Acked-by: Rob Herring <robh at kernel.org>
---
.../devicetree/bindings/mailbox/mtk-gce.txt | 43 ++++++++++++++++++++++
1 file changed, 43 insertions(+)
create mode 100644 Documentation/devicetree/bindings/mailbox/mtk-gce.txt
diff --git a/Documentation/devicetree/bindings/mailbox/mtk-gce.txt b/Documentation/devicetree/bindings/mailbox/mtk-gce.txt
new file mode 100644
index 0000000..d2d3ccb
--- /dev/null
+++ b/Documentation/devicetree/bindings/mailbox/mtk-gce.txt
@@ -0,0 +1,43 @@
+MediaTek GCE
+===============
+
+The Global Command Engine (GCE) is used to help read/write registers with
+critical time limitation, such as updating display configuration during the
+vblank. The GCE can be used to implement the Command Queue (CMDQ) driver.
+
+CMDQ driver uses mailbox framework for communication. Please refer to
+mailbox.txt for generic information about mailbox device-tree bindings.
+
+Required properties:
+- compatible: Must be "mediatek,mt8173-gce"
+- reg: Address range of the GCE unit
+- interrupts: The interrupt signal from the GCE block
+- clock: Clocks according to the common clock binding
+- clock-names: Must be "gce" to stand for GCE clock
+- #mbox-cells: Should be 2
+
+Required properties for a client device:
+- mboxes: client use mailbox to communicate with GCE, it should have this
+ property and list of phandle, mailbox channel specifiers, and atomic
+ execution flag.
+
+Example:
+
+ gce: gce at 10212000 {
+ compatible = "mediatek,mt8173-gce";
+ reg = <0 0x10212000 0 0x1000>;
+ interrupts = <GIC_SPI 135 IRQ_TYPE_LEVEL_LOW>;
+ clocks = <&infracfg CLK_INFRA_GCE>;
+ clock-names = "gce";
+
+ #mbox-cells = <2>;
+ };
+
+Example for a client device:
+
+ mmsys: clock-controller at 14000000 {
+ compatible = "mediatek,mt8173-mmsys";
+ mboxes = <&gce 0 1 /* main display with atomic execution */
+ &gce 1 1>; /* sub display with atomic execution */
+ ...
+ };
--
1.9.1
More information about the linux-arm-kernel
mailing list