[PATCH 2/2] tty: serial: Makefile: move kgdb to be initialized last

[Nicolae Rosia]

From: Nicolae Rosia <nicolae_rosia at mentor.com>

fsl_lpuart cannot be used with kgdb because the kgdb
initcall is called before the driver's init.
Move kgdb to be initialized after all serial drivers
have been inited.

Signed-off-by: Nicolae Rosia <nicolae_rosia at mentor.com>
Signed-off-by: Stefan Golinschi <stefan.golinschi at gmail.com>
---
 drivers/tty/serial/Makefile | 5 +++--
 1 file changed, 3 insertions(+), 2 deletions(-)

diff --git a/drivers/tty/serial/Makefile b/drivers/tty/serial/Makefile
index 1278d37..8016ef9 100644
--- a/drivers/tty/serial/Makefile
+++ b/drivers/tty/serial/Makefile
@@ -62,13 +62,11 @@ obj-$(CONFIG_SERIAL_ATMEL) += atmel_serial.o
 obj-$(CONFIG_SERIAL_UARTLITE) += uartlite.o
 obj-$(CONFIG_SERIAL_MSM) += msm_serial.o
 obj-$(CONFIG_SERIAL_NETX) += netx-serial.o
-obj-$(CONFIG_SERIAL_KGDB_NMI) += kgdb_nmi.o
 obj-$(CONFIG_SERIAL_KS8695) += serial_ks8695.o
 obj-$(CONFIG_SERIAL_OMAP) += omap-serial.o
 obj-$(CONFIG_SERIAL_ALTERA_UART) += altera_uart.o
 obj-$(CONFIG_SERIAL_ST_ASC) += st-asc.o
 obj-$(CONFIG_SERIAL_TILEGX) += tilegx.o
-obj-$(CONFIG_KGDB_SERIAL_CONSOLE) += kgdboc.o
 obj-$(CONFIG_SERIAL_QE) += ucc_uart.o
 obj-$(CONFIG_SERIAL_TIMBERDALE)	+= timbuart.o
 obj-$(CONFIG_SERIAL_GRLIB_GAISLER_APBUART) += apbuart.o
@@ -96,3 +94,6 @@ obj-$(CONFIG_SERIAL_MPS2_UART)	+= mps2-uart.o
 
 # GPIOLIB helpers for modem control lines
 obj-$(CONFIG_SERIAL_MCTRL_GPIO)	+= serial_mctrl_gpio.o
+
+obj-$(CONFIG_SERIAL_KGDB_NMI) += kgdb_nmi.o
+obj-$(CONFIG_KGDB_SERIAL_CONSOLE) += kgdboc.o
-- 
2.5.5