[RFC PATCH v2 2/2] macb: Enable 1588 support in SAMA5D2 platform.

[Andrei Pistirica]

On 20.11.2016 20:54, Richard Cochran wrote:
> On Fri, Nov 18, 2016 at 03:21:52PM +0100, Andrei Pistirica wrote:
>> diff --git a/drivers/net/ethernet/cadence/macb.c b/drivers/net/ethernet/cadence/macb.c
>> index d975882..eb66b76 100644
>> --- a/drivers/net/ethernet/cadence/macb.c
>> +++ b/drivers/net/ethernet/cadence/macb.c
>> @@ -697,6 +697,8 @@ static void macb_tx_interrupt(struct macb_queue *queue)
>>
>>  			/* First, update TX stats if needed */
>>  			if (skb) {
>> +				macb_ptp_do_txstamp(bp, skb);
>
> This is in the hot path, and so you should have an inline wrapper that
> tests (bp->hwts_tx_en) and THEN calls into macb_ptp.c

Ack.

>
> In case PTP isn't configured, then the inline wrapper should be empty.
>
>>  				netdev_vdbg(bp->dev, "skb %u (data %p) TX complete\n",
>>  					    macb_tx_ring_wrap(tail), skb->data);
>>  				bp->stats.tx_packets++;
>> @@ -853,6 +855,8 @@ static int gem_rx(struct macb *bp, int budget)
>>  		    GEM_BFEXT(RX_CSUM, ctrl) & GEM_RX_CSUM_CHECKED_MASK)
>>  			skb->ip_summed = CHECKSUM_UNNECESSARY;
>>
>> +		macb_ptp_do_rxstamp(bp, skb);
>
> Same here.
>
>>  		bp->stats.rx_packets++;
>>  		bp->stats.rx_bytes += skb->len;
>>
>> @@ -1946,6 +1950,8 @@ static int macb_open(struct net_device *dev)
>>
>>  	netif_tx_start_all_queues(dev);
>>
>> +	macb_ptp_init(dev);
>
> This leaks PHC instances starting the second time that the interface goes up!

Yes, I will call unregister at interface down.

>
>>  	return 0;
>>  }
>>
>> @@ -2204,7 +2210,7 @@ static const struct ethtool_ops gem_ethtool_ops = {
>>  	.get_regs_len		= macb_get_regs_len,
>>  	.get_regs		= macb_get_regs,
>>  	.get_link		= ethtool_op_get_link,
>> -	.get_ts_info		= ethtool_op_get_ts_info,
>> +	.get_ts_info		= macb_get_ts_info,
>
> You enable the time stamping logic unconditionally here ...

I will add a wrapper to test if macb is gem and if it has PTP 
capability, otherwise call ethtool_op_get_ts_info.

>
>>  	.get_ethtool_stats	= gem_get_ethtool_stats,
>>  	.get_strings		= gem_get_ethtool_strings,
>>  	.get_sset_count		= gem_get_sset_count,
>> @@ -2221,7 +2227,14 @@ static int macb_ioctl(struct net_device *dev, struct ifreq *rq, int cmd)
>>  	if (!phydev)
>>  		return -ENODEV;
>>
>> -	return phy_mii_ioctl(phydev, rq, cmd);
>> +	switch (cmd) {
>> +	case SIOCSHWTSTAMP:
>> +		return macb_hwtst_set(dev, rq, cmd);
>> +	case SIOCGHWTSTAMP:
>> +		return macb_hwtst_get(dev, rq);
>
> and here.
>
> Is that logic always available on every MACB device?  If so, is the
> implementation also identical?

As before, I will add a wrapper and the related tests.

>
> Thanks,
> Richard
>

Regards,
Andrei