Synopsys Ethernet QoS Driver

[Joao Pinto]

On 23-11-2016 11:41, Lars Persson wrote:
> 
>> 23 nov. 2016 kl. 12:11 skrev Joao Pinto <Joao.Pinto at synopsys.com>:
>>
>> Hi Peppe and Lars,
>>
>>> On 23-11-2016 10:59, Giuseppe CAVALLARO wrote:
>>> Hello Joao, Lars.
>>>
>>>> On 11/22/2016 3:16 PM, Joao Pinto wrote:
>>>>>> Ok, it makes sense.
>>>>>> Just for curiosity the target setup is the following:
>>>>>> https://www.youtube.com/watch?v=8V-LB5y2Cos
>>>>>> but instead of using internal drivers, we desire to use mainline drivers only.
>>>>>>
>>>>>> Thanks!
>>>> Regarding this subject, I am thinking of making the following adaption:
>>>>
>>>> a) delete ethernet/synopsys
>>>> b) rename ethernet/stmicro/stmmac to ethernet/synopsys
>>>>
>>>> and send you a patch for you to evaluate. Both agree with the approach?
>>>> To have a new work base would be important, because I will add to the "new"
>>>> structure some missing QoS features like Multichannel support, CBS and later TSN.
>>>
>>> IMO, we have to agree on a common strategy making the change for
>>> net-next; I imaged the following steps:
>>
>> Yes it makes totally sense.
>>
>>>
>>> - to port missing feature or fixes from ethernet/synopsys
>>>  inside the stmmac taking care about the documentation too.
>>
>> @Lars: You are familiar with the synopsys qos driver. Could you please do this
>> porting. You can also make an analysis of what to port and I can do the porting
>> for you if you don't have the availability for it.
> 
> As my main duty is changing diapers until March next year, please go ahead with this step if you can spend time on it before I am back in office.

Congratulations :)!

> 
> Rabin Vincent can review and test that the port works properly on our Artpec-chips that use dwc_eth_qos.c today.
> 
> The main porting step is to implement the device tree binding in bindings/net/snps,dwc-qos-ethernet.txt. Also our chip has a strict requirement that the phy is enabled when the SWR reset bit is set (it needs a tx clock to complete the reset).
> 
> - Lars

Ok, I will do the task.

@Peppe: Agree with the plan?

> 
>>
>>> - remove ethernet/synopsys
>>> - rename ethernet/stmicro/stmmac to ethernet/synopsys
>>
>> I volunteer to do this task.
>>
>>>
>>>  These latest two have some relevant impacts.
>>>
>>>  This change should be propagated to all the platforms that are using:
>>>      CONFIG_SYNOPSYS_DWC_ETH_QOS and CONFIG_STMMAC_ETH
>>>  plus device-tree compatibility.
>>
>> I volunteer to do this task also.
>>
>>>
>>> - enhance the stmmac with new features and new glue (part of these
>>>  can be anticipated for sure).
>>
>> I have to implement 3 new features for now, but I will take some time for it, so
>> I would suggest to make the previous task and incrementally add features.
>>
>>>
>>> what do you think? does it make sense? If yes, we can also
>>> understand how/who starts.
>>>
>>> Regards,
>>> Peppe
>>
>> Thanks and regards.
>>
>> Joao
>>
>>>
>>>> Thanks.
>>>
>>