[RESEND PATCH 2/3] ARM: davinci: hawk: Remove vbus and over current gpios

[Sekhar Nori]

On Tuesday 22 November 2016 09:11 PM, Axel Haslam wrote:
> Hi Sekhar
> 
> On Tue, Nov 22, 2016 at 11:37 AM, Sekhar Nori <nsekhar at ti.com> wrote:
>> On Monday 21 November 2016 10:23 PM, Axel Haslam wrote:
>>> The hawk board VBUS is fixed to a 5v source, and the over
>>> current pin is actually not connected to the SoC.
>>>
>>> Do not reseve these gpios for OHCI as they are not related
>>> to usb.
>>>
>>> Signed-off-by: Axel Haslam <ahaslam at baylibre.com>
>>
>> As discussed over the MMC/SD patches, this patch should be based off the
>> hawkboard schematic, not the LCDK schematic.
>>
> 
> I looked at the hawkboard schematics and they are the same
> as the lcdk as far as usb i concerned:
> 
> The ohci vbus is fixed to 5v, and the over current pins of the
> TPS are not connected. so this patch should be ok for
> both the hawk and the lcdk.

Alright! Thanks for checking.

Regards,
Sekhar