[PATCH] arm64: tegra: Add VDD_GPU regulator to Jetson TX1
Thierry Reding
thierry.reding at gmail.com
Tue Nov 22 08:16:02 PST 2016
From: Alexandre Courbot <acourbot at nvidia.com>
Add the VDD_GPU regulator (a GPIO-enabled PWM regulator) to the Jetson
TX1 board. This addition allows the GPU to be used provided the
bootloader properly enabled the GPU node.
Signed-off-by: Alexandre Courbot <acourbot at nvidia.com>
Signed-off-by: Thierry Reding <treding at nvidia.com>
---
Hi ARM-SoC maintainers,
This was part of a pull request for v4.8 but it seems everything of the
pull request except this one patch made it upstream. I think perhaps it
may have been the dependency on the regulator tree that made you defer
this to after v4.8-rc1 and then I forgot to resend.
Here's a link to the pull request:
http://lists.infradead.org/pipermail/linux-arm-kernel/2016-July/443469.html
There was no discussion on the list, but we might have discussed it on
IRC.
Can you please pick this up for v4.10-rc1?
Thanks,
Thierry
arch/arm64/boot/dts/nvidia/tegra210-p2180.dtsi | 18 ++++++++++++++++++
1 file changed, 18 insertions(+)
diff --git a/arch/arm64/boot/dts/nvidia/tegra210-p2180.dtsi b/arch/arm64/boot/dts/nvidia/tegra210-p2180.dtsi
index 5fda583351d7..906fb836d241 100644
--- a/arch/arm64/boot/dts/nvidia/tegra210-p2180.dtsi
+++ b/arch/arm64/boot/dts/nvidia/tegra210-p2180.dtsi
@@ -21,6 +21,10 @@
reg = <0x0 0x80000000 0x1 0x0>;
};
+ gpu at 57000000 {
+ vdd-supply = <&vdd_gpu>;
+ };
+
/* debug port */
serial at 70006000 {
status = "okay";
@@ -291,4 +295,18 @@
clock-frequency = <32768>;
};
};
+
+ regulators {
+ vdd_gpu: regulator at 100 {
+ compatible = "pwm-regulator";
+ reg = <100>;
+ pwms = <&pwm 1 4880>;
+ regulator-name = "VDD_GPU";
+ regulator-min-microvolt = <710000>;
+ regulator-max-microvolt = <1320000>;
+ enable-gpios = <&pmic 6 GPIO_ACTIVE_HIGH>;
+ regulator-ramp-delay = <80>;
+ regulator-enable-ramp-delay = <1000>;
+ };
+ };
};
--
2.10.2
More information about the linux-arm-kernel
mailing list