[PATCH] ata: xgene: Enable NCQ support for APM X-Gene SATA controller hardware v1.1

[Rameshwar Sahu]

Hi Olof/Tejun,

On Thu, Oct 20, 2016 at 4:44 PM, Rameshwar Prasad Sahu <rsahu at apm.com> wrote:
>
> This patch enables NCQ support for APM X-Gene SATA controller
> hardware v1.1 that was broken with hardware v1.0.
>
> Signed-off-by: Rameshwar Prasad Sahu <rsahu at apm.com>
> ---
>  drivers/ata/ahci_xgene.c |   14 ++++++++------
>  1 files changed, 8 insertions(+), 6 deletions(-)
>
> diff --git a/drivers/ata/ahci_xgene.c b/drivers/ata/ahci_xgene.c
> index 73b19b2..8b88be9 100644
> --- a/drivers/ata/ahci_xgene.c
> +++ b/drivers/ata/ahci_xgene.c
> @@ -87,6 +87,7 @@
>
>  enum xgene_ahci_version {
>         XGENE_AHCI_V1 = 1,
> +       XGENE_AHCI_V1_1,
>         XGENE_AHCI_V2,
>  };
>
> @@ -734,6 +735,7 @@ static struct scsi_host_template ahci_platform_sht = {
>  #ifdef CONFIG_ACPI
>  static const struct acpi_device_id xgene_ahci_acpi_match[] = {
>         { "APMC0D0D", XGENE_AHCI_V1},
> +       { "APMC0D67", XGENE_AHCI_V1_1},
>         { "APMC0D32", XGENE_AHCI_V2},
>         {},
>  };
> @@ -742,6 +744,7 @@ MODULE_DEVICE_TABLE(acpi, xgene_ahci_acpi_match);
>
>  static const struct of_device_id xgene_ahci_of_match[] = {
>         {.compatible = "apm,xgene-ahci", .data = (void *) XGENE_AHCI_V1},
> +       {.compatible = "apm,xgene-ahci-v1-1", .data = (void *) XGENE_AHCI_V1_1},
>         {.compatible = "apm,xgene-ahci-v2", .data = (void *) XGENE_AHCI_V2},
>         {},
>  };
> @@ -755,8 +758,7 @@ static int xgene_ahci_probe(struct platform_device *pdev)
>         struct resource *res;
>         const struct of_device_id *of_devid;
>         enum xgene_ahci_version version = XGENE_AHCI_V1;
> -       const struct ata_port_info *ppi[] = { &xgene_ahci_v1_port_info,
> -                                             &xgene_ahci_v2_port_info };
> +       const struct ata_port_info *ppi;
>         int rc;
>
>         hpriv = ahci_platform_get_resources(pdev);
> @@ -821,8 +823,6 @@ static int xgene_ahci_probe(struct platform_device *pdev)
>                                 dev_warn(&pdev->dev, "%s: Error reading device info. Assume version1\n",
>                                         __func__);
>                                 version = XGENE_AHCI_V1;
> -                       } else if (info->valid & ACPI_VALID_CID) {
> -                               version = XGENE_AHCI_V2;
>                         }
>                 }
>         }
> @@ -858,18 +858,20 @@ skip_clk_phy:
>
>         switch (version) {
>         case XGENE_AHCI_V1:
> +               ppi = &xgene_ahci_v1_port_info;
>                 hpriv->flags = AHCI_HFLAG_NO_NCQ;
>                 break;
>         case XGENE_AHCI_V2:
> +               ppi = &xgene_ahci_v2_port_info;
>                 hpriv->flags |= AHCI_HFLAG_YES_FBS;
>                 hpriv->irq_handler = xgene_ahci_irq_intr;
>                 break;
>         default:
> +               ppi = &xgene_ahci_v1_port_info;
>                 break;
>         }
>
> -       rc = ahci_platform_init_host(pdev, hpriv, ppi[version - 1],
> -                                    &ahci_platform_sht);
> +       rc = ahci_platform_init_host(pdev, hpriv, ppi, &ahci_platform_sht);
>         if (rc)
>                 goto disable_resources;
>
> --
> 1.7.1


Any comment on above patch ??