[PATCH 2/8] ARM64: dts: meson-gxl: Add pinctrl nodes

[Kevin Hilman]

Neil Armstrong <narmstrong at baylibre.com> writes:

> Add pinctrl nodes and pin definitions for Amlogic Meson GXL.
>
> Signed-off-by: Neil Armstrong <narmstrong at baylibre.com>
> ---
>  arch/arm64/boot/dts/amlogic/meson-gxl.dtsi | 168 +++++++++++++++++++++++++++++
>  1 file changed, 168 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/amlogic/meson-gxl.dtsi b/arch/arm64/boot/dts/amlogic/meson-gxl.dtsi
> index 13b10ee..ce7f550 100644
> --- a/arch/arm64/boot/dts/amlogic/meson-gxl.dtsi
> +++ b/arch/arm64/boot/dts/amlogic/meson-gxl.dtsi
> @@ -42,7 +42,175 @@
>   */
>  
>  #include "meson-gx.dtsi"
> +#include <dt-bindings/gpio/meson-gxl-gpio.h>

Oops, this has a dependency on the patch going through the pinctrl tree,
which causes probelems we like to avoid in the arm-soc tree.

For now, I've changed this to use the GXBB include since the values used
are the same, but we can fix this for good in v4.10-rc, after the GXL
pinctrl changes are merged.

Kevin

[1] [PATCH] pinctrl: meson: Add GXL pinctrl definitions
>  / {
>  	compatible = "amlogic,meson-gxl";
>  };
> +
> +&aobus {
> +	pinctrl_aobus: pinctrl at 14 {
> +		compatible = "amlogic,meson-gxl-aobus-pinctrl";
> +		#address-cells = <2>;
> +		#size-cells = <2>;
> +		ranges;
> +
> +		gpio_ao: bank at 14 {
> +			reg = <0x0 0x00014 0x0 0x8>,
> +			      <0x0 0x0002c 0x0 0x4>,
> +			      <0x0 0x00024 0x0 0x8>;
> +			reg-names = "mux", "pull", "gpio";
> +			gpio-controller;
> +			#gpio-cells = <2>;
> +		};
> +
> +		uart_ao_a_pins: uart_ao_a {
> +			mux {
> +				groups = "uart_tx_ao_a", "uart_rx_ao_a";
> +				function = "uart_ao";
> +			};
> +		};
> +
> +		remote_input_ao_pins: remote_input_ao {
> +			mux {
> +				groups = "remote_input_ao";
> +				function = "remote_input_ao";
> +			};
> +		};
> +	};
> +};
> +
> +&periphs {
> +	pinctrl_periphs: pinctrl at 4b0 {
> +		compatible = "amlogic,meson-gxl-periphs-pinctrl";
> +		#address-cells = <2>;
> +		#size-cells = <2>;
> +		ranges;
> +
> +		gpio: bank at 4b0 {
> +			reg = <0x0 0x004b0 0x0 0x28>,
> +			      <0x0 0x004e8 0x0 0x14>,
> +			      <0x0 0x00120 0x0 0x14>,
> +			      <0x0 0x00430 0x0 0x40>;
> +			reg-names = "mux", "pull", "pull-enable", "gpio";
> +			gpio-controller;
> +			#gpio-cells = <2>;
> +		};
> +
> +		emmc_pins: emmc {
> +			mux {
> +				groups = "emmc_nand_d07",
> +				       "emmc_cmd",
> +				       "emmc_clk",
> +				       "emmc_ds";
> +				function = "emmc";
> +			};
> +		};
> +
> +		sdcard_pins: sdcard {
> +			mux {
> +				groups = "sdcard_d0",
> +				       "sdcard_d1",
> +				       "sdcard_d2",
> +				       "sdcard_d3",
> +				       "sdcard_cmd",
> +				       "sdcard_clk";
> +				function = "sdcard";
> +			};
> +		};
> +
> +		sdio_pins: sdio {
> +			mux {
> +				groups = "sdio_d0",
> +				       "sdio_d1",
> +				       "sdio_d2",
> +				       "sdio_d3",
> +				       "sdio_cmd",
> +				       "sdio_clk";
> +				function = "sdio";
> +			};
> +		};
> +
> +		sdio_irq_pins: sdio_irq {
> +			mux {
> +				groups = "sdio_irq";
> +				function = "sdio";
> +			};
> +		};
> +
> +		uart_a_pins: uart_a {
> +			mux {
> +				groups = "uart_tx_a",
> +				       "uart_rx_a";
> +				function = "uart_a";
> +			};
> +		};
> +
> +		uart_b_pins: uart_b {
> +			mux {
> +				groups = "uart_tx_b",
> +				       "uart_rx_b";
> +				function = "uart_b";
> +			};
> +		};
> +
> +		uart_c_pins: uart_c {
> +			mux {
> +				groups = "uart_tx_c",
> +				       "uart_rx_c";
> +				function = "uart_c";
> +			};
> +		};
> +
> +		i2c_a_pins: i2c_a {
> +			mux {
> +				groups = "i2c_sck_a",
> +				     "i2c_sda_a";
> +				function = "i2c_a";
> +			};
> +		};
> +
> +		i2c_b_pins: i2c_b {
> +			mux {
> +				groups = "i2c_sck_b",
> +				      "i2c_sda_b";
> +				function = "i2c_b";
> +			};
> +		};
> +
> +		i2c_c_pins: i2c_c {
> +			mux {
> +				groups = "i2c_sck_c",
> +				      "i2c_sda_c";
> +				function = "i2c_c";
> +			};
> +		};
> +
> +		eth_pins: eth_c {
> +			mux {
> +				groups = "eth_mdio",
> +				       "eth_mdc",
> +				       "eth_clk_rx_clk",
> +				       "eth_rx_dv",
> +				       "eth_rxd0",
> +				       "eth_rxd1",
> +				       "eth_rxd2",
> +				       "eth_rxd3",
> +				       "eth_rgmii_tx_clk",
> +				       "eth_tx_en",
> +				       "eth_txd0",
> +				       "eth_txd1",
> +				       "eth_txd2",
> +				       "eth_txd3";
> +				function = "eth";
> +			};
> +		};
> +
> +		pwm_e_pins: pwm_e {
> +			mux {
> +				groups = "pwm_e";
> +				function = "pwm_e";
> +			};
> +		};
> +	};
> +};