[PATCH V3 1/6] clk: tegra: add TEGRA20_CLK_NOR to init table

[Mirza Krak]

2016-11-03 13:26 GMT+01:00 Mirza Krak <mirza.krak at gmail.com>:
> 2016-11-03 11:06 GMT+01:00 Jon Hunter <jonathanh at nvidia.com>:
>> Hi Mirza,
>>
>> On 27/10/16 15:01, Mirza Krak wrote:
>>>
>>> From: Mirza Krak <mirza.krak at gmail.com>
>>>
>>> Add TEGRA20_CLK_NOR to init table and set default rate to 92 MHz which
>>> is max rate.
>>>
>>> The maximum rate value of 92 MHz is pulled from the downstream L4T
>>> kernel.
>>
>>
>> Thanks for adding this. I assume that this is from an L4T r16 release with a
>> v3.1 kernel. I had a quick poke through the kernel sources for v3.1 but was
>> unable to see where this is set. Obviously v3.1 did not have CCF and so
>> everything seems to be in the arch/arm/mach-tegra directory for setting up
>> clocks. Can you point me to the appropriate sources so I can ACK this?
>
> I use the kernel sources provided by Toradex, and these sources are
> based on L4T r16 release.
>
> http://git.toradex.com/cgit/linux-toradex.git/tree/arch/arm/mach-tegra/tegra2_clocks.c?h=tegra#n2463

Ops, pre-mature send.

I also added Marcel from Toradex on CC.

The link to the source are [1] for Tegra2 and  [2] for Tegra3.

[1]. http://git.toradex.com/cgit/linux-toradex.git/tree/arch/arm/mach-tegra/tegra2_clocks.c?h=tegra#n2463
[2]. http://git.toradex.com/cgit/linux-toradex.git/tree/arch/arm/mach-tegra/tegra3_clocks.c?h=tegra#n4353

Best Regards
Mirza