[PATCH v3 0/6] add NS2 support to bgmac

[Jon Mason]

On Tue, Nov 01, 2016 at 11:01:19AM -0700, Scott Branden wrote:
> Hi Jon,
> 
> On 16-11-01 10:51 AM, Jon Mason wrote:
> >Changes in v3:
> >* Clean-up the bgmac DT binding doc (per Rob Herring)
> >* Document the lane swap binding and make it generic (Per Andrew Lunn)
> Where is the documentation of the lane swap binding?

Sent out the wrong branch :(

Sending out v4 shortly with this patch.

> 
> >
> >
> >Changes in v2:
> >* Remove the PHY power-on (per Andrew Lunn)
> >* Misc PHY clean-ups regarding comments and #defines (per Andrew Lunn)
> >  This results on none of the original PHY code from Vikas being
> >  present.  So, I'm removing him as an author and giving him
> >  "Inspired-by" credit.
> >* Move PHY lane swapping to PHY driver (per Andrew Lunn and Florian
> >  Fainelli)
> >* Remove bgmac sleep (per Florian Fainelli)
> >* Re-add bgmac chip reset (per Florian Fainelli and Ray Jui)
> >* Rebased on latest net-next
> >* Added patch for bcm54xx_auxctl_read, which is used in the BCM54810
> >
> >
> >Add support for the amac found in the Broadcom Northstar2 SoC to the
> >bgmac driver.  This necessitates adding support to connect to an
> >externally defined phy (as described in the device tree) in the driver.
> >These phy changes are in addition to the changes necessary to get NS2
> >working.
> >
> >
> >Jon Mason (6):
> >  net: phy: broadcom: add bcm54xx_auxctl_read
> >  net: phy: broadcom: Add BCM54810 PHY entry
> >  Documentation: devicetree: net: add NS2 bindings to amac
> >  net: ethernet: bgmac: device tree phy enablement
> >  net: ethernet: bgmac: add NS2 support
> >  arm64: dts: NS2: add AMAC ethernet support
> >
> > .../devicetree/bindings/net/brcm,amac.txt          |  16 ++--
> > arch/arm64/boot/dts/broadcom/ns2-svk.dts           |   5 ++
> > arch/arm64/boot/dts/broadcom/ns2.dtsi              |  12 +++
> > drivers/net/ethernet/broadcom/bgmac-bcma.c         |  48 ++++++++++
> > drivers/net/ethernet/broadcom/bgmac-platform.c     | 100 ++++++++++++++++++++-
> > drivers/net/ethernet/broadcom/bgmac.c              |  55 ++----------
> > drivers/net/ethernet/broadcom/bgmac.h              |   8 ++
> > drivers/net/phy/Kconfig                            |   2 +-
> > drivers/net/phy/broadcom.c                         |  68 +++++++++++++-
> > include/linux/brcmphy.h                            |  11 +++
> > 10 files changed, 268 insertions(+), 57 deletions(-)
> >