[PATCH 2/5] clocksource: rockchip: remove unnecessary clear irq before request_irq

Huang, Tao huangtao at rock-chips.com
Tue May 31 19:30:36 PDT 2016


Hi Doug:
On 2016年06月01日 01:03, Doug Anderson wrote:
> Hi,
> 
> On Mon, May 30, 2016 at 4:09 PM, Daniel Lezcano
> <daniel.lezcano at linaro.org> wrote:
>> On 05/25/2016 11:49 AM, Caesar Wang wrote:
>>>
>>> From: Huang Tao <huangtao at rock-chips.com>
>>>
>>> rk_timer_interrupt_clear and rk_timer_disable is unnecessary before
>>> request_irq. Timer should keep disabled before booting Linux.
>>
>>
>> That's true in the perfect world :/ Some version has u-boot letting the
>> timer with irq enabled, therefore as soon as request_irq is done, an irq
>> fires and leads to a kernel panic.
>>
>> On the other side, this timer is not used on the other rockchip version than
>> rk3399 because of no need of a broadcast timer, so removing these two lines
>> may be acceptable.
>>
>> Can try the changes with another board, eg rk3288 (and forcing to use this
>> timer). Can you do the test and confirm it does not break with different
>> version of u-boot ?
> 
> Actually, I'm not even sure that's true in a perfect world.  ;)  There
> are two main problems that might be lurking here:
> 
> 1. On exynos5 devices I've worked with, the private timer (MCT)
> actually shared the same physical counter with the ARM Architected
> Timer.  IIRC stopping or resetting the MCT had the effect of stopping
> / resetting the Arch Timer.  Is it the same for you?  As I understand
> it the Arch Timer isn't supposed to ever be stopped or reset.  If
> firmware left the timer stopped and the kernel happened to be compiled
> without support for the Rockchip timer (but had the Arch Timers) then
> things would be very broken.  Also the early kernel boot might be
> broken if the Arch Timer inits before the Rockchip timer.
> 
> NOTE: If your timer and the Arch Timer are totally separate then point
> #1 is not important.

We never use the timer which provide clock source of arch timer as
clockevent timer. If we do such stupid thing, when rk timer disabled,
the arch timer will stop too. Generally, we use this special timer as
clocksouce or never touch it again when it is running.

> 
> 
> 2. Historically in Chrome OS there's been an unofficial agreement that
> the firmware would start its high speed timer as soon as possible at
> bootup and that this could be used to (roughly) measure the time
> between the start of firmware and the start of the kernel.  That means
> that the kernel was expecting the timer to actually be running when it
> started up.  Yup, this is a bit of a hack and I'm not sure it's
> terribly well documented, but it does provide a reason that firmware
> might have left the timer running.

Why you chose the timer shared with Linux kernel, there are so many
timer? I think loader should do the right thing, uninit the resources
when it boot the kernel. I believe this code is lagacy from very old
chip such as rk2908 which is Cortex-A8. There are not arch timer, so the
loader may keep the timer running when enter kernel. Any way, if we
adopt the code suggested by Daniel, it is safe to keep the code.




More information about the linux-arm-kernel mailing list