[PATCH 2/2] ARM: dts: imx6q: add support for the Utilite Pro

[Christopher Spinrath]

Hi Fabio,

On 05/24/2016 01:20 AM, Fabio Estevam wrote:
> Hi Christopher,
> 
> On Mon, May 23, 2016 at 8:08 PM, Christopher Spinrath
> <christopher.spinrath at rwth-aachen.de> wrote:
> 
>> I would like to but I'm not sure if I'm allowed to. As I stated in the
>> license header some nodes are copied (and cleaned up) from the vendor
>> kernel/devicetree. They are licensed GPL-v2 only. So I don't know, can I
>> add the X11 license?
> 
> Maybe you could contact the original author anc check?
> 
I have sent an email to the author and will wait about a week for a
reply before I send v2.

>>> Better to avoid 0x80000000. Replace it with the real iomux value
>>> instead so that you don't need to rely on the bootloader
>>> configuration.
>> hmm, I don't know how to determine this value. The device documentation
>> I have does not say anything about it and the vendor kernel uses
>> 0x80000000...
> 
> The default value of register IOMUXC_SW_PAD_CTL_PAD_ENET_TX_DATA1 is
> 0x1b0b0, so you can use this value.
>
> Another thing I forgot to comment: instead of putting this pin inside
> the hog group you could put it inside the gpio-keys node.
> 

OK, done. Can I always use the default value in this case? If yes, can
you point me to a proper documentation of these?

Thanks,
Christopher